Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM6422 Other Parts Discussed in Thread: SK-AM64B , , CDCLVC1310
Tool/software:
Hi,
In AM6422 evaluation board SK-AM64B. It connect the EXT_REFCLK1 to CLKOUT0 signal. i have some question about it.
1. EXT_REFCLK1 is 3.3V. Why it connect…
Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
On Sitara Family of Processors, there are multiple instances of I2C present.
Some of the I2C instances are available in the MAIN Domain[example: SoC_I2C0…
Part Number: AM625 Other Parts Discussed in Thread: AM62P ,
Tool/software:
Hi TI Experts,
Could you provide S-parameter and IBIS model of IO-buffer for performing simulations
Part Number: AM625
Tool/software:
Hi Team,
My customer is creating their PCB and have a few questions.
Is there any recommendations or recommended values (for interconnect length or CLK-to-DATA interconnect difference) for the peripherals below…
Part Number: AM625
Tool/software:
Hi Team,
My customer has questions about JTAG pulldown/pullup.
Regarding the TCK, TDI, TMS signals, is pullup required?
It does not seem to be mentioned in the datasheet and says in the link below that it depends…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP
Tool/software:
Hi, My customer is using SD card boot only for development phase. For production, only QSPI boot is used. QSPI or SD card boot selection is done by DIP switch on the board…
