TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197743 Discussions
  • Not Answered

    FFT implementation using C6678 intrinsics 0 Locked

    797 views
    3 replies
    Latest over 11 years ago
    by Arunmoezhi Ramachandran
  • Answered

    C55x5: Block Floating Point 0 Locked

    284 views
    1 reply
    Latest over 11 years ago
    by Mark M
  • Answered

    C6748 Reset pin 0 Locked

    250 views
    3 replies
    Latest over 11 years ago
    by Chris Roed
  • Not Answered

    OMAP3530 ARM access DSP L2RAM cause kernel panic 0 Locked

    245 views
    0 replies
    Started over 11 years ago
    by Airie Zhou
  • Answered

    Linux target file system lacks apt-get and sudo 0 Locked

    5847 views
    7 replies
    Latest over 11 years ago
    by Josh Elliott
  • Not Answered

    DM365 Non-static image as OSD 0 Locked

    184 views
    0 replies
    Started over 11 years ago
    by Robert Moore
  • Not Answered

    DVFS voltage ramp rate 0 Locked

    183 views
    1 reply
    Latest over 11 years ago
    by Antony Samsunil
  • Answered

    BIOS_getCpuFreq() on C6678 0 Locked

    1423 views
    3 replies
    Latest over 11 years ago
    by Ashish Kapania
  • Answered

    How to generate a lib(*.ae674) for the C674x-DSP on DM8168? 0 Locked

    3953 views
    16 replies
    Latest over 11 years ago
    by ARM3035
  • Not Answered

    C551x: Serial NOR boot 0 Locked

    185 views
    1 reply
    Latest over 11 years ago
    by Steve Tsang
  • Answered

    DDR3 for TMS320C6672 0 Locked

    584 views
    7 replies
    Latest over 11 years ago
    by Alex Watson
  • Suggested Answer

    Unexpected VOut1_HSYNC(HDCOMP_HSYNC) 0 Locked

    378 views
    1 reply
    Latest over 11 years ago
    by Steve Clynes
  • Not Answered

    C553x: SDXC support 0 Locked

    177 views
    1 reply
    Latest over 11 years ago
    by Steve Tsang
  • Answered

    omapl138 lcdk button press - led 0 Locked

    880 views
    6 replies
    Latest over 11 years ago
    by Jeremy Warner
  • Suggested Answer

    TMS320C5505 eZdsp help 0 Locked

    371 views
    1 reply
    Latest over 11 years ago
    by Vasantha K
  • Answered

    about c6657 ddr sw leveling calculate 0 Locked

    626 views
    1 reply
    Latest over 11 years ago
    by Bill Taboada
  • Not Answered

    C6678 Multicore SPI Boot 0 Locked

    1054 views
    1 reply
    Latest over 11 years ago
    by Rahul Prabhu
  • Not Answered

    DM365 clkout0 signal 0 Locked

    427 views
    1 reply
    Latest over 11 years ago
    by BrandonAzbell
  • Not Answered

    DSP C6412 can't connect JTAG 0 Locked

    529 views
    5 replies
    Latest over 11 years ago
    by Bill Taboada
  • Answered

    Why ARM can access the address range from 0xc0000000 to 0xFFFFFFFF via mmap on xtcievmk2x? 0 Locked

    953 views
    1 reply
    Latest over 11 years ago
    by Rex Chang
<>