TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197753 Discussions
  • Not Answered

    dm365 frame problem during H264 encoding 0 Locked

    162 views
    0 replies
    Started over 11 years ago
    by ShauWoo Hsu
  • Not Answered

    AM335x: NOR BOOT non muxed questions 0 Locked

    267 views
    1 reply
    Latest over 11 years ago
    by Biser Gatchev-XID
  • Answered

    How to capture and display video on the DM816x evm board? 0 Locked

    655 views
    11 replies
    Latest over 11 years ago
    by basavaraju Gandla
  • Answered

    Problem in enabling eMMC in DM8148 custom board 0 Locked

    456 views
    3 replies
    Latest over 11 years ago
    by Pavel Botev
  • Not Answered

    USB Webcam with OMAP-L138 LCDK 0 Locked

    501 views
    3 replies
    Latest over 11 years ago
    by Pubesh
  • Not Answered

    How to transfer UV Data using EDMA in DM8127 0 Locked

    332 views
    0 replies
    Started over 11 years ago
    by JeongHwan Park
  • Answered

    GPMC TIMEOUTSTARTVALUE units 0 Locked

    185 views
    2 replies
    Latest over 11 years ago
    by Ivan Frederiks
  • Not Answered

    DM8168 smartreflex 0 Locked

    433 views
    1 reply
    Latest over 11 years ago
    by K Md Feroz Irfan
  • Answered

    How to load .out file without flashing in Linux 0 Locked

    125 views
    1 reply
    Latest over 11 years ago
    by Pubesh
  • Answered

    dsp selection for open cv 0 Locked

    163 views
    1 reply
    Latest over 11 years ago
    by Pubesh
  • Suggested Answer

    Question about DDR3 initialization during SPI boot 0 Locked

    573 views
    2 replies
    Latest over 11 years ago
    by g.f.
  • Not Answered

    DSPLINK problem 0 Locked

    317 views
    1 reply
    Latest over 11 years ago
    by Cvetolin Shulev-XID
  • Not Answered

    what comes instead ezsdk for dm8168 evm? 0 Locked

    308 views
    1 reply
    Latest over 11 years ago
    by Badri Narayanan
  • Not Answered

    DM8168 encode/decode capability in DVRRDk 4.0 NVR specifications:8ch 1080P30 decode? 0 Locked

    245 views
    1 reply
    Latest over 11 years ago
    by Badri Narayanan
  • Answered

    DM3730's power management unit(TPS65910) can not work 0 Locked

    471 views
    7 replies
    Latest over 11 years ago
    by hao wang92287
  • Not Answered

    porting the SONY FCBEH6500 module on DM36x , but the color of whole Image is wrong 0 Locked

    133 views
    0 replies
    Started over 11 years ago
    by simon liao
  • Not Answered

    OMAPFLASH v4.15 operation fail<Remort:-> unknown command Driver> Error 0 Locked

    468 views
    1 reply
    Latest over 11 years ago
    by Cvetolin Shulev-XID
  • Suggested Answer

    how to set the osd format 0 Locked

    218 views
    2 replies
    Latest over 11 years ago
    by billy david
  • Not Answered

    Beaglebone 0 Locked

    107 views
    1 reply
    Latest over 11 years ago
    by Biser Gatchev-XID
  • Answered

    AM335x StarterKit WL1271 Calibration Instructions 0 Locked

    1258 views
    3 replies
    Latest over 11 years ago
    by Kedar
<>