Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TDA4VM
There is some issue in my ethernet link. I wanted to do a sanity check using MAC loopback and see if the MAC is working well or not. Is there an easy way to do this?
Part Number: AM62A7 Other Parts Discussed in Thread: AM62D-Q1 , AM62A3 , , AM62A3-Q1 , , SK-AM62A-LP , SYSCONFIG
Hi TI Experts,
Can you provide a List of collaterals that can be referred when starting a custom board hardware design.
Part Number: AM6442
This FAQ showcase how to use the following TISCI APIs in AM64x/AM243x MCU+SDK - TISCI_MSG_READ_KEYCNT_KEYREV - TISCI_MSG_WRITE_KEYREV
Part Number: AM62x, AM62Ax, AM64x, AM65x
Overview
Multilib is one of the solutions allowing users to run applications built for various application binary interfaces (ABIs) of the same architecture. One use of this is to run 32-bit applications built…
Part Number: AM335x, AM437x, AM62x, AM62Ax, AM64x, AM65x
Overview
This E2E FAQ shows an alternative approach of how to use an Yocto-internal toolchain for image builds as well as for the associated SDK installer generation that contains the cross…
Other Parts Discussed in Thread: AM620-Q1 , AM62P , AM625 Hi TI Experts,
I have the below queries regarding the OLDI interface
Supported display configurations. Query regarding 8-lane, 4-lane and electrical compatibility.
Is there a recommended…
Part Number: TDA4VM I do not have UART boot mode on my custom board due to lack of switch / pins which can configure the boot mode. Is there a way by which I can change the boot mode in software using gel scripts?
