TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198209 Discussions
  • Not Answered

    c6713 EDMA+MCBSP to link AIC23 problems 0 Locked

    489 views
    3 replies
    Latest over 12 years ago
    by RandyP
  • Not Answered

    DM365 Keyscan Driver Stops Sending events 0 Locked

    303 views
    1 reply
    Latest over 12 years ago
    by YJ Liu
  • Answered

    DM8148 uboot: nand speed is very low? 0 Locked

    5302 views
    25 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Answered

    Error when bootup 0 Locked

    408 views
    7 replies
    Latest over 12 years ago
    by Mark Duda
  • Answered

    The description of EMIF Register 0 Locked

    243 views
    1 reply
    Latest over 12 years ago
    by BrandonAzbell
  • Not Answered

    why OMAP PSP WebEx Presentations is not working ? 0 Locked

    300 views
    2 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Not Answered

    Boxcar filter too slow 0 Locked

    571 views
    3 replies
    Latest over 12 years ago
    by RandyP
  • Answered

    who can mail omap-l138 starterware files to me.. 0 Locked

    268 views
    2 replies
    Latest over 12 years ago
    by Adrien brody
  • Not Answered

    Any one help me with the jffs2 fs on the DM8168 when booting the kernel. 0 Locked

    3095 views
    2 replies
    Latest over 12 years ago
    by zhu ted
  • Not Answered

    How to use ALSA in the AM1808 McBSP? 0 Locked

    190 views
    0 replies
    Started over 12 years ago
    by Hirohumi Watanabe
  • Not Answered

    Problems with Flashing the bootloader 0 Locked

    97 views
    1 reply
    Latest over 12 years ago
    by Ivan Pang
  • Answered

    AM3335x-EVM Linux SDK on Beaglebone 0 Locked

    419 views
    4 replies
    Latest over 12 years ago
    by Geoffrey Olson1
  • Not Answered

    C553x Memory-Mapped Registers for Boot-Time Register Configuration 0 Locked

    238 views
    2 replies
    Latest over 12 years ago
    by asd asd
  • Answered

    How to set DM8148 SD_VENC to By-pass Mode? 0 Locked

    1089 views
    9 replies
    Latest over 12 years ago
    by Michael Williamson
  • Not Answered

    C6748 Clock cycle in the OMAP L138 0 Locked

    295 views
    0 replies
    Started over 12 years ago
    by Muhammad Zaigham Abbas Shah
  • Not Answered

    AM3359 SPI Issue with Transmit-Only Slave 0 Locked

    490 views
    2 replies
    Latest over 12 years ago
    by Greg Davis1
  • Answered

    CCS commands for C55BootImage 0 Locked

    509 views
    1 reply
    Latest over 12 years ago
    by Steve Tsang
  • Not Answered

    NEED INFORMATION- OMAPL138BGWTMEP 0 Locked

    214 views
    2 replies
    Latest over 12 years ago
    by Wade Vonbergen
  • Answered

    Evaluation Modules with XDS560V2 Emulation 0 Locked

    622 views
    6 replies
    Latest over 12 years ago
    by Chad Courtney
  • Answered

    OS requirements for development environments 0 Locked

    220 views
    4 replies
    Latest over 12 years ago
    by Aaron Hill
<>