TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM69A: BOOTING FROM EMMC WITHOUT SD CARD

    Gokul Praveen
    Gokul Praveen
    Part Number: AM69A Other Parts Discussed in Thread: AM69 Tool/software: How to boot from eMMC without SD card?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Undeclared Identifier for MCU GPIO Interrupt Routers

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I am trying to upgrade my project to use the new MCU+ SDK 10.1 and I'm running into a compilation error saying that the interrupt router number is undeclared. This…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x (ALV) / AM335x Design Recommendations / Custom board hardware design - Schematics review checklists

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62L Tool/software: Hi Board designers The AM64x, AM62x, AM62Ax, AM62D-Q1, AM62Px and AM62L custom board Schematic review Checklist application note provides a supplemental design check…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: Deploy MMYOLO on AM62A, YOLOV8 nano as example.

    Adam Hua
    Adam Hua
    Part Number: AM62A7-Q1 Tool/software: MMYOLO is an open source repo for quick yolo model evaluation. Deployment MMYOLO on TI processor like AM6x or TDAx requires some modifications on this repo. This FAQ uses yolov8 as example to demonstrate how to…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to SysConfig-PinMux IOSET and Voltage Conflict

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Tool/software: Hi TI Experts, I see IOSET option and Voltage Conflict indication while using SysConfig-PinMux. Can you provide additional inputs on the IOSET and Voltage configuration
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Incorrect auto-generated MAC port 2 PHY configuration

    Nitika Verma
    Nitika Verma
    Part Number: SK-AM64B Other Parts Discussed in Thread: DP83869 , SYSCONFIG Tool/software: The two Ethernet Ports on SK-AM64x are connected to two separate Gigabit Ethernet PHY Transceivers DP83867. On enabling MAC Port 2 in SK-AM64x networking…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Queries related to passive components values, tolerance, voltage rating

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, 1. In the SK/EVM i see 49.9K resistor used. Can i use a standard value instead 2. In the SK/EVM i see a number of resistors used with 1% tolerance for pullups and series resistors. Can i use standard…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design – Queries related to Residual Voltage, Detection and supply decay

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6594-Q1 , AM62P Tool/software: HI TI experts, I have the below queries related to residual voltage 1. What are the causes for Residual Voltage 2. Effect of Residual Voltage on…
    • Answered
    • 9 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7-Q1: SDIO driver strength change

    Biao Li
    Biao Li
    Part Number: AM62A7-Q1 Other Parts Discussed in Thread: AM62A7 Tool/software: Hi Expert, Customer was doing EMC test, it was found that the EMMC CLOCK exceeded the standard by 10dB at 1.8GHz and 1.6GHz. Can the output strength capability of the…
    • 9 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198400 Discussions
  • Not Answered

    AM335X EVM schematics 0 Locked

    293 views
    0 replies
    Started over 13 years ago
    by gregory hermant
  • Answered

    can't create platinum encoder h264enc on dm365 0 Locked

    495 views
    6 replies
    Latest over 13 years ago
    by Gunjan
  • Not Answered

    Jtag error with DM6437 0 Locked

    213 views
    0 replies
    Started over 13 years ago
    by ~Inoui ~
  • Discussion

    Beagle Board Not booting and LEDs also not blinking Locked

    322 views
    0 replies
    Started over 13 years ago
    by Naven Yanamaddi
  • Not Answered

    NAND flash interface to OMAP 3530 0 Locked

    182 views
    0 replies
    Started over 13 years ago
    by narasimha reddy72258
  • Not Answered

    DM6435 resizer sample code issues 0 Locked

    214 views
    2 replies
    Latest over 13 years ago
    by K Md Feroz Irfan
  • Answered

    6678EVM ethernet reception 0 Locked

    289 views
    1 reply
    Latest over 13 years ago
    by Aviv
  • Answered

    Formatting SD Card with One Partition using scripting.. 0 Locked

    426 views
    3 replies
    Latest over 13 years ago
    by Manuel Contreras
  • Not Answered

    linux targetfs on OMAP3 0 Locked

    174 views
    0 replies
    Started over 13 years ago
    by yuqing cai
  • Not Answered

    evm C6678 board network seems work on only half duplex mode 0 Locked

    341 views
    3 replies
    Latest over 13 years ago
    by Lucifar He
  • Not Answered

    How to Execute am335x_Diagnostics_10Feb2012_Alpha_Beta on Am335x EVM Board 0 Locked

    868 views
    1 reply
    Latest over 13 years ago
    by Raghavendra Hegde
  • Not Answered

    Bug in lsz file transfer? 0 Locked

    883 views
    1 reply
    Latest over 13 years ago
    by Helmut Forren
  • Not Answered

    AM3517 can bus support 10k bitrate 0 Locked

    208 views
    0 replies
    Started over 13 years ago
    by Huang Luna
  • Discussion

    This is a Serial Transfer utility for DM6467T (and others) <-> Host Computer (PC tested) Locked

    2175 views
    3 replies
    Latest over 13 years ago
    by Helmut Forren
  • Not Answered

    pre compiled UBL and Uboot images 0 Locked

    213 views
    1 reply
    Latest over 13 years ago
    by Christian Riesch
  • Not Answered

    how to boot AM1808 with out UBL 0 Locked

    211 views
    1 reply
    Latest over 13 years ago
    by Christian Riesch
  • Not Answered

    Touch Screen Calibration Test 0 Locked

    4755 views
    11 replies
    Latest over 13 years ago
    by Muhammad Salih
  • Answered

    How do I fix higher speed baud rates on DM6467? 0 Locked

    3167 views
    18 replies
    Latest over 13 years ago
    by Helmut Forren
  • Not Answered

    Usage of ipcFramesOutLink and processLink 0 Locked

    281 views
    1 reply
    Latest over 13 years ago
    by Mingqian
  • Not Answered

    Using PSP 04.00.00.09 and can't boot from NOR or NAND 0 Locked

    952 views
    2 replies
    Latest over 13 years ago
    by chei siang ng
<>