TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198289 Discussions
  • Not Answered

    McBSP2 - I2S Sample Rate Generator 0 Locked

    153 views
    0 replies
    Started over 13 years ago
    by Larry Harmon
  • Not Answered

    How to integrate DM8168 with DP83848C(National PHY chip)? 0 Locked

    197 views
    1 reply
    Latest over 13 years ago
    by Benoit Parrot
  • Not Answered

    How to swap in my own DSP algorithm for the Davinci encodedecode demo app? 0 Locked

    187 views
    0 replies
    Started over 13 years ago
    by Dennis C
  • Answered

    how to see debug info in ccs4? 0 Locked

    443 views
    6 replies
    Latest over 13 years ago
    by free bigfish
  • Answered

    PRD Object not finished in time for next Tick 0 Locked

    262 views
    1 reply
    Latest over 13 years ago
    by David Friedland
  • Answered

    ti-sdk-am37x-evm-05.02.00.00 on CCSv5 0 Locked

    1855 views
    17 replies
    Latest over 13 years ago
    by Robert Tivy
  • Not Answered

    C6678 DDR3 questions 0 Locked

    562 views
    3 replies
    Latest over 13 years ago
    by Chad Courtney
  • Answered

    TMS320C6745 clock structure 0 Locked

    479 views
    3 replies
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    OMX_EZSDK "capture_encode_a8host_debug.xv5t" 0 Locked

    244 views
    1 reply
    Latest over 13 years ago
    by _Ralph_
  • Not Answered

    C6457(VCP, TCP) simulator in ccs4 0 Locked

    252 views
    0 replies
    Started over 13 years ago
    by Khawar Shahzad86276
  • Not Answered

    When I set configuration of make builder as http://processors.wiki.ti.com/index.php/How_to_Build_the_Matrix_GUI#Select_the_Build_Configuration,I get an error as image as below if I click OK.That is : java.lang.illegalArgumentExcept:Index out of bounds R 0 Locked

    835 views
    1 reply
    Latest over 13 years ago
    by Marcel Stumpel
  • Answered

    Linux Kernel Hangs at start up 0 Locked

    1060 views
    5 replies
    Latest over 13 years ago
    by Florin Matei
  • Answered

    problem using FFMPEG to extract h264 clip 0 Locked

    426 views
    2 replies
    Latest over 13 years ago
    by Hongfeng Wang
  • Not Answered

    Capture Frame (Skipped Frame logic) 0 Locked

    265 views
    1 reply
    Latest over 13 years ago
    by Brijesh Jadav
  • Answered

    problems building qt with tslib 0 Locked

    3430 views
    5 replies
    Latest over 13 years ago
    by dj42901
  • Discussion

    C674x FreeRTOS port Locked

    663 views
    0 replies
    Started over 13 years ago
    by Dmitry
  • Answered

    Slaveloader missing file ! 0 Locked

    530 views
    7 replies
    Latest over 13 years ago
    by MALAUD Baptiste
  • Answered

    Boot order and board init 0 Locked

    1424 views
    5 replies
    Latest over 13 years ago
    by Mark K
  • Not Answered

    SPS/PPS H.264 Parameters 0 Locked

    629 views
    0 replies
    Started over 13 years ago
    by Charles McCallum
  • Answered

    Building FrameQ four core application 0 Locked

    2819 views
    13 replies
    Latest over 13 years ago
    by Arnie Reynoso
<>