TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198299 Discussions
  • Answered

    C6743 @ 200 MHz with 133 MHz SDRAM ? 0 Locked

    226 views
    2 replies
    Latest over 14 years ago
    by Stephane Lesage
  • Not Answered

    About PCI boot with auto-initialization mode of DM648 0 Locked

    2116 views
    18 replies
    Latest over 14 years ago
    by taiduan ye
  • Not Answered

    Problem with SAR channel2 on the TMS320VC5505 0 Locked

    599 views
    4 replies
    Latest over 14 years ago
    by julien1986
  • Answered

    What's happened when I memset the L1D cache? 0 Locked

    729 views
    6 replies
    Latest over 14 years ago
    by D.C. Tseng
  • Not Answered

    DM365 RDK Build Error - Undefined SUSPEND_DISABLE 0 Locked

    389 views
    1 reply
    Latest over 14 years ago
    by Marcus Cooksey
  • Not Answered

    Help starting with the codec engine 0 Locked

    185 views
    0 replies
    Started over 14 years ago
    by Subin P Thomas
  • Not Answered

    lcd flickers in android on every mouse movement 0 Locked

    577 views
    2 replies
    Latest over 14 years ago
    by Mahesh Ingle
  • Not Answered

    VFP on AM3703 0 Locked

    420 views
    3 replies
    Latest over 14 years ago
    by Frank Walzer
  • Not Answered

    AM37xx DSP/BIOS Support? 0 Locked

    189 views
    2 replies
    Latest over 14 years ago
    by Norman Wong
  • Not Answered

    RS232 communication not working with PC and EVM5505 0 Locked

    271 views
    3 replies
    Latest over 14 years ago
    by Anand CV
  • Not Answered

    Power management in Linux. 0 Locked

    201 views
    1 reply
    Latest over 14 years ago
    by Anil
  • Not Answered

    NDK with DM6437 0 Locked

    258 views
    0 replies
    Started over 14 years ago
    by nethaji d
  • Not Answered

    DM6437 with ethernet !!!!! 0 Locked

    613 views
    11 replies
    Latest over 14 years ago
    by nethaji d
  • Not Answered

    SPI Latency on 816x 0 Locked

    123 views
    1 reply
    Latest over 14 years ago
    by Mansoor Ahamed
  • Not Answered

    Arago OE build problems with linux-omap-psp_2.6.32 0 Locked

    379 views
    0 replies
    Started over 14 years ago
    by jaydubya
  • Answered

    DSPLib DSPF_sp_mat_trans corrupts stack on c6747 0 Locked

    469 views
    2 replies
    Latest over 14 years ago
    by Irina Reshodko71204
  • Not Answered

    OMAP 3530 SPI1 SOMI (Slave Out Master In ) not working 0 Locked

    426 views
    3 replies
    Latest over 14 years ago
    by Vini
  • Not Answered

    SPI DMA Cache Flush issue 0 Locked

    1102 views
    10 replies
    Latest over 14 years ago
    by david atkins
  • Answered

    DM365 MPEG4 encode noise at inputWidth>=160 0 Locked

    1218 views
    13 replies
    Latest over 14 years ago
    by Yoichi
  • Not Answered

    C6A8168 Power Requirement 0 Locked

    511 views
    15 replies
    Latest over 14 years ago
    by MarcPyne
<>