TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197743 Discussions
  • Not Answered

    NOR flash for AM3505 0 Locked

    363 views
    2 replies
    Latest over 14 years ago
    by TME -RL
  • Not Answered

    problem in booting from SPI flash in logic PD EVM using SOM C6748.very critical 0 Locked

    151 views
    0 replies
    Started over 14 years ago
    by shilpa 55162
  • Answered

    VPFE questions (2) 0 Locked

    355 views
    3 replies
    Latest over 14 years ago
    by Anonymous
  • Not Answered

    Graph tool enhancements. . . 0 Locked

    161 views
    1 reply
    Latest over 14 years ago
    by Michael T
  • Answered

    Does PWM has current limitation? 0 Locked

    453 views
    8 replies
    Latest over 14 years ago
    by Anonymous
  • Answered

    Availablity of AM1x chips 0 Locked

    206 views
    2 replies
    Latest over 14 years ago
    by Anonymous
  • Not Answered

    RBL problem: problems loading UBL 0 Locked

    250 views
    0 replies
    Started over 14 years ago
    by HvW
  • Not Answered

    How to assign virtual memory size in davinci kernel 0 Locked

    237 views
    1 reply
    Latest over 14 years ago
    by Michael T
  • Not Answered

    The effect between DRV_frameCopy() and ALG_vidDecRun() functions 0 Locked

    421 views
    0 replies
    Started over 14 years ago
    by Parry Huang
  • Answered

    Why twiddle table is loaded twice in memory? 0 Locked

    261 views
    1 reply
    Latest over 14 years ago
    by Dimitris Kaliakmanis
  • Not Answered

    DM6446 UImage Booting Issue 0 Locked

    245 views
    0 replies
    Started over 14 years ago
    by Peter Jerald
  • Not Answered

    why dm365 MDFS bit always is 0? 0 Locked

    326 views
    5 replies
    Latest over 14 years ago
    by Aen
  • Answered

    DM365 with cmos sensor 0 Locked

    1066 views
    13 replies
    Latest over 14 years ago
    by marcus lu
  • Answered

    Not receving any data on ttyUSB0 0 Locked

    4775 views
    14 replies
    Latest over 14 years ago
    by Ajay
  • Answered

    AM17x (or AM18x) EVM schematic and pcb files 0 Locked

    441 views
    4 replies
    Latest over 14 years ago
    by Venkatesh P V
  • Not Answered

    DM3730 monochrome jpeg support 0 Locked

    174 views
    0 replies
    Started over 14 years ago
    by Patrick Marshall
  • Not Answered

    Color R&B are exchanged after entering QT 0 Locked

    261 views
    2 replies
    Latest over 14 years ago
    by Prabindh Sundareson
  • Answered

    bsp_cfg.h and bsp_cfg.inc, are they supposed to hold the same values pinmux registers?? 0 Locked

    286 views
    1 reply
    Latest over 14 years ago
    by DavidVescovi
  • Not Answered

    How to solve the JPEGDEC_END_OF_IMAGE error ? 0 Locked

    118 views
    0 replies
    Started over 14 years ago
    by Akira Karasudani
  • Not Answered

    Framerate dropped suddenly when running encode demo on dm6467 0 Locked

    429 views
    2 replies
    Latest over 14 years ago
    by zhifei zhang
<>