TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198213 Discussions
  • Answered

    Does FlahBurn Support Evm L138?Any other methods to burn nand? 0 Locked

    304 views
    2 replies
    Latest over 14 years ago
    by McFly
  • Not Answered

    DM355 Startup/Example Code for SPI and UART 0 Locked

    218 views
    1 reply
    Latest over 14 years ago
    by Tai Nguyen
  • Answered

    add 1080p H.264 encode demo on DM6467T EVM board 0 Locked

    559 views
    7 replies
    Latest over 14 years ago
    by th
  • Answered

    Question about the internal pull-up and pull-down resistors of C6472 0 Locked

    326 views
    3 replies
    Latest over 14 years ago
    by BrandonAzbell
  • Answered

    Can't open source file xdc/std.h 0 Locked

    9602 views
    23 replies
    Latest over 14 years ago
    by AmitMookerjee
  • Answered

    OS requirement & interrupt questions 0 Locked

    266 views
    1 reply
    Latest over 14 years ago
    by Kevin S
  • Not Answered

    Request guidance on DVSDK 4.00 target filesystem preparation 0 Locked

    210 views
    2 replies
    Latest over 14 years ago
    by BrandonAzbell
  • Answered

    An Interrupt controller question 0 Locked

    232 views
    2 replies
    Latest over 14 years ago
    by RandyP
  • Answered

    C6745 Boot modes 0 Locked

    333 views
    1 reply
    Latest over 14 years ago
    by RandyP
  • Not Answered

    Not able to debug C6455 Evaluation Module 0 Locked

    187 views
    1 reply
    Latest over 14 years ago
    by RandyP
  • Answered

    How to use the SDMA drive of OMAP3530 0 Locked

    429 views
    1 reply
    Latest over 14 years ago
    by craja
  • Answered

    camera driver example code in WINCE AM35X,AM/DM37X version 0 Locked

    337 views
    4 replies
    Latest over 14 years ago
    by Jennifer Zou
  • Not Answered

    video signal processing 0 Locked

    175 views
    0 replies
    Started over 14 years ago
    by mingjing yu
  • Not Answered

    DM642 video signal processing 0 Locked

    281 views
    0 replies
    Started over 14 years ago
    by mingjing yu
  • Not Answered

    Are there any details in loading code to DM365 IRAM with slh_36x? 0 Locked

    246 views
    0 replies
    Started over 14 years ago
    by German Baranov
  • Not Answered

    How does Android routes voice call audio? 0 Locked

    776 views
    2 replies
    Latest over 14 years ago
    by mshklyarman
  • Not Answered

    DM648 NDK instability ? 0 Locked

    234 views
    0 replies
    Started over 14 years ago
    by dp
  • Not Answered

    NDK support DM648, but how about DM647 support? 0 Locked

    176 views
    0 replies
    Started over 14 years ago
    by Kai-jiun Yang
  • Answered

    C6474EVM Timer interrupt and DSP/Bios 0 Locked

    1165 views
    13 replies
    Latest over 14 years ago
    by bala ganapathy
  • Not Answered

    how do the parameter of web post to dm365 IPcam board 0 Locked

    179 views
    1 reply
    Latest over 14 years ago
    by willis
<>