TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM62x & AM64x: How to enable PRU RPMsg on Processor SDK Linux 11.0

    Nick Saulnier
    Nick Saulnier
    Part Number: PROCESSOR-SDK-AM62X PROCESSOR-SDK-AM64X In Linux kernel 6.12, we remove the separate PRU RPMsg (RPMessage) driver, and use the generic RPMsg driver instead. However, the changes were not complete in time for Linux SDK 11.0. This means that…
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK: Getting Started with GPIOs in Linux using the AM62 and AM64 Family Processors

    Anshu Madwesh
    Anshu Madwesh
    Part Number: PROCESSOR-SDK-AM62X Other Parts Discussed in Thread: AM62P , AM62L , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62A-LP , SK-AM62P-LP , SYSCONFIG Tool/software: The objective of this FAQ is for someone with a TI EVM to enable using GPIOs…
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to enable MCU R5F cores running in split mode in SPL boot flow.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Tool/software: TI SDKs by default configures MCU R5F running in lock step mode, how to configure to run MCU R5F in Split Mode.
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: How do I control the quality of service (QoS) and class of service (CoS) settings on TDA4 devices to balance transaction loads and priorities?

    Jared McArthur
    Jared McArthur
    Part Number: TDA4VH-Q1 Other Parts Discussed in Thread: TDA4VH , J784S4XEVM Tool/software: I'm seeing issues with the display experiencing sync losts when running the TIDL AVP demo. How do I balance the transaction loads and priorities so that the DSS…
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62x, AM62Px, AM62D-Q1, AM64x, AM243x: 4KB Sector Erase Fails

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: PROCESSOR-SDK-AM62X Tool/software: Greetings, When working with a flash part like S25HL512T or S28HS512T , one will come across Uniform vs Hybrid mode. The points which this FAQ covers is: What is Uniform vs Hybrid Mode for the…
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM62A-LP: Is USB OTG possible without PD controller?

    Sathiya Narayanan
    Sathiya Narayanan
    Part Number: SK-AM62A-LP Other Parts Discussed in Thread: AM62P , SK-AM62P-LP , PROCESSOR-SDK-AM62A Tool/software: Hi, For my application, I don't need PD controller for power negotiation. But in SK-AM62A-LP design, PD controller is also used for…
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: Error while registration of same MAC address with different VLAN to ETHFW server from client.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Tool/software: ETHFW returns error while registration of same MAC address with different VLAN from same client. This issue is observed on 10.1 TI SDK.
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7: How to Enable Edge Enhancement on TDA4x/AM6xA

    Chau Le
    Chau Le
    Part Number: AM62A7 Tool/software: I have my tuned DCC Edge Enhancement binaries, how do I enable EE modules to take effect on my (SK) Edge AI device?
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM62Ax / AM62D-Q1 / AM62Px / AM64x / AM243x (ALV, ALX) Design Recommendations / Custom board hardware design - Processor Reset inputs, Reset Status Outputs and Connection Recommendations

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62P , AM62D-Q1 , TPS65224-Q1 , AM6442 Tool/software: HI TI experts, I have queries related to supported reset inputs and reset status outputs Supported Reset inputs Recommended connections…
    • Answered
    • 6 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62D-Q1 / AM62Px / AM64x / AM243x (ALV, ALX) Design Recommendations / Custom board hardware design – Power OK (POK) Module Voltages Monitored and Connection recommendations

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM620 Other Parts Discussed in Thread: AM625 , AM62P Tool/software: HI TI experts, I have queries related to the POK modules for AM6x family of processors Supported voltage monitors Voltage monitors that required external voltage…
    • 6 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198433 Discussions
  • Not Answered

    DM647 PRST Problem 0 Locked

    413 views
    4 replies
    Latest over 15 years ago
    by B.C.
  • Answered

    OMAP-L137 0 Locked

    358 views
    7 replies
    Latest over 15 years ago
    by Mukul Bhatnagar
  • Not Answered

    Setting up interrupts using DSP/BIOS on a c5502 0 Locked

    373 views
    4 replies
    Latest over 15 years ago
    by TommyG
  • Answered

    RTSC target and platform information for C6472 0 Locked

    315 views
    2 replies
    Latest over 15 years ago
    by mans
  • Not Answered

    Can do encoding 3M & 5M Pixel by H.264 at DM365 or DM368 ? 0 Locked

    1562 views
    8 replies
    Latest over 15 years ago
    by Anshuman Saxena
  • Not Answered

    dm365 decode 0 Locked

    418 views
    4 replies
    Latest over 15 years ago
    by Miguel A. Alanis
  • Suggested Answer

    dm365 - eMMC formatting 0 Locked

    291 views
    1 reply
    Latest over 15 years ago
    by Constantine
  • Not Answered

    DSPLIB: DSPF_sp_fftSPxSP radix question 0 Locked

    997 views
    2 replies
    Latest over 15 years ago
    by tanger tang
  • Suggested Answer

    bootargs list and definitions 0 Locked

    455 views
    3 replies
    Latest over 15 years ago
    by Sekhar Nori
  • Not Answered

    Using TMS3206416T's internal ADC 0 Locked

    377 views
    4 replies
    Latest over 15 years ago
    by Sarmad
  • Suggested Answer

    Does anybody run em2860 or em28xx web camera on DM355 EVM? 0 Locked

    293 views
    1 reply
    Latest over 15 years ago
    by Anshuman Saxena
  • Not Answered

    TMS320C6457 EMIF 0 Locked

    195 views
    1 reply
    Latest over 15 years ago
    by AnBer
  • Not Answered

    How increase baud-rate? 0 Locked

    428 views
    3 replies
    Latest over 15 years ago
    by Paul.Yin
  • Answered

    DM365IPNC-IMX035 by APPRO setup issues 0 Locked

    6774 views
    45 replies
    Latest over 15 years ago
    by sujit mahapatro
  • Answered

    [C6748] Voltage change 0 Locked

    290 views
    6 replies
    Latest over 15 years ago
    by Eiji Fukawa
  • Not Answered

    DM6467 EMIF data transfer corruption problem 0 Locked

    438 views
    2 replies
    Latest over 15 years ago
    by Santoshkumar Pattar
  • Not Answered

    HELP ! Data Pause Problem —— 6713 EMIF interfacing the parallel DAC 0 Locked

    955 views
    12 replies
    Latest over 15 years ago
    by xiaoer han
  • Answered

    GSG: DM365 DVEVM Software Setup for MontaVista Kernel for building a New lInux kernel issue 0 Locked

    753 views
    5 replies
    Latest over 15 years ago
    by Anshuman Saxena
  • Not Answered

    DM365 EVM 0 Locked

    144 views
    1 reply
    Latest over 15 years ago
    by Jeff Hayes
  • Answered

    OMAPL137 freezeed at "Waiting for SFT on the OMAP-L137" by using FlashAndBootUtils_2_11 0 Locked

    902 views
    1 reply
    Latest over 15 years ago
    by jc-ti
<>