Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] DRA821U: How to test RGMII with DRA821 on EVM

    Part Number: DRA821U Other Parts Discussed in Thread: DRA821 How to test RGMII configuration with DRA821 on EVM ? As only SGMII is enabled by default ?

  • [FAQ] TDA4VM: Resource table for IPC

    Part Number: TDA4VM Other Parts Discussed in Thread: SYSBIOS Where can I find the resource table for IPC application running on MCU1_0. Also, what resource table should I use when loading another core?

  • [FAQ] TDA4VM: How to Configure CPSW 5G/9G ALE

    Part Number: TDA4VM How to configure CPSW 5G/9G to add static entries ?

  • [FAQ] TDA4VM: how to load MAIN core images from eMMC with boot_app

    Part Number: TDA4VM To enable fast CAN response, I need to use SBL to load MCU1_0 image (either AUTOSAR or TI-RTOS). boot_app_mcu_rtos is the demo ap p in SDK release for the early CAN response implementation. The boot app inside can be used to boot…

  • [FAQ] J7200XSOMXEVM: How to use the QSGMII expansion board with DRA821 SDK V7.3

    Part Number: J7200XSOMXEVM Other Parts Discussed in Thread: DRA821 I have got the DRA821 EVM (J7200 SOM, and J7 common processor board), and also the "Quad-Port Ethernet expansion board" (a.k.a QSGMII expansion board). J7200 SOM: https://www.ti.com…

  • [FAQ] DRA821U: change app_remoteswitchcfg_server log UART port

    Part Number: DRA821U Other Parts Discussed in Thread: DRA821 I am working on a customer DRA821 board. As the default UART port isn't available for the ethernet firmware log output. How can I change the log output to another UART instance?

  • [FAQ] PROCESSOR-SDK-J721E: Support for PAN and Zoom in display node in OpenVX

    Part Number: PROCESSOR-SDK-J721E This post explains how we can add support for panning and zoom functionality in the display node in OpenVX.

  • [FAQ] PROCESSOR-SDK-J721E: How to capture different types/formats of camera from the single CSIRX port ?

    Part Number: PROCESSOR-SDK-J721E This article explains how to capture different types/formats of cameras from same CSIRX port in OpenVX.

  • [FAQ] TDA4VM: I do not see CPSW5G/9G interface when booting up with Linux on J7200/J721E devices

    Part Number: TDA4VM I do not see the eth1 interface when booting up with Linux on J7200/J721E devices using SD Card, there is no output on 3rd Main UART instance as well where Ethernet Firmware output usually comes.

  • [FAQ] TDA4VM: Cddipc between mcu1_0(mcusw) and mcu2_1(mcusw) based on SDK v7.3

    Part Number: TDA4VM I am working on the integration of the Cddipc into AUTOSAR, which runs on MCU1_0 and MCU2_1. I want to achieve the IPC between MCU1_0(running AUTOSAR) and MCU2_1(also running AUTOSAR). My environment is as below: TDA4VM SDK…

View FAQ threads
  • Threads 198934 Discussions