TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197749 Discussions
  • Discussion

    Davinci/OMAP System Integration using Linux Workshop: Materials Now Available! Locked

    405 views
    0 replies
    Started over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    From beginner: MMC access in Code Composer Studio (OMAP-L137) 0 Locked

    1031 views
    15 replies
    Latest over 15 years ago
    by RIZUAN
  • Answered

    There is not the rated value of PLLM / PLLOUT in case of 375MHz. 0 Locked

    325 views
    3 replies
    Latest over 15 years ago
    by tlee
  • Suggested Answer

    Urgent!!! ACPY3_wait() function doesn't wait really 0 Locked

    349 views
    4 replies
    Latest over 15 years ago
    by Gunjan
  • Not Answered

    MJCP and MPEG4 in DM355 0 Locked

    423 views
    5 replies
    Latest over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    how can i use vicp lib to improve h.264 bp on dm6446? 0 Locked

    173 views
    3 replies
    Latest over 15 years ago
    by Paul.Yin
  • Answered

    MSGQ Link Error 0 Locked

    407 views
    2 replies
    Latest over 15 years ago
    by Dennis Nguyen
  • Not Answered

    OMAP L138 McBsp0 and McAsp0 using the PSPDRIVERS 0 Locked

    287 views
    0 replies
    Started over 15 years ago
    by Fernando Pimenta
  • Not Answered

    What part of DM365 program is built using CCS? 0 Locked

    247 views
    2 replies
    Latest over 15 years ago
    by Roman Gavrilov
  • Not Answered

    Building Arago file system 0 Locked

    986 views
    2 replies
    Latest over 15 years ago
    by Denys Dmytriyenko
  • Not Answered

    Audio processing with DSP on omap3530 0 Locked

    694 views
    0 replies
    Started over 15 years ago
    by Jean FAYE
  • Answered

    linker error building for 64x of OMAP 35x EVM board 0 Locked

    306 views
    2 replies
    Latest over 15 years ago
    by rmb_vector
  • Suggested Answer

    H.264 Codec Development on DM6467 1Ghz 0 Locked

    490 views
    5 replies
    Latest over 15 years ago
    by Iain Hunter
  • Answered

    Problem with MSGQ_get in Worker Thread 0 Locked

    1028 views
    10 replies
    Latest over 15 years ago
    by SNBANIK
  • Not Answered

    signal passthrough VC5505 0 Locked

    571 views
    2 replies
    Latest over 15 years ago
    by Juliane Huettl
  • Not Answered

    LCD LIDD 8bit mode? 0 Locked

    475 views
    4 replies
    Latest over 15 years ago
    by Roger
  • Answered

    Problem with Converting MPEG4 ASP to H.264 on DM365 0 Locked

    220 views
    2 replies
    Latest over 15 years ago
    by Yashwant Dutt
  • Not Answered

    GPIO read write 0 Locked

    455 views
    1 reply
    Latest over 15 years ago
    by Mario Raffin
  • Not Answered

    SRIO message passing on evm 6474 0 Locked

    223 views
    2 replies
    Latest over 15 years ago
    by Mugiwara
  • Not Answered

    DSP MMU Error PCE1 0 Locked

    524 views
    6 replies
    Latest over 15 years ago
    by coroger
<>