TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DM R5F can crash in certain conditions: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A This is the companion FAQ for [FAQ] [Alert] DM R5F can crash in certain conditions: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A Please read the alert first. General questions What is the root cause…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ): Custom Board Hardware design - PORz and RTC_PORz slew rate

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts, Usually add RC filter on RESET signal to anti-noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms, can it meet AM62x reset…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: Enable Display Frame Freeze safety feature in openvx

    Gokul S
    Gokul S
    Part Number: TDA4VH-Q1 Tool/software: DSS includes a hardware-enabled freeze frame checker at each pipeline output and vp output. When enabled, it generates a data signature of pixels from a user define region for each frame. The current frame signature…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ) Design Recommendations / Custom board hardware design – Guidelines and E2E query links for custom board designers to refer

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts I see the below status on TI.com for AM62L Can you provide additional inputs on the collaterals to be referred or guidelines to follow during custom board design
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - Supported bootmode configurations

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM62D-Q1 , AM625 , AM623 , AM620-Q1 Tool/software: Hi TI experts help me understand the supported bootmode configurations for the below family of processors AM625 / AM623 / AM620-Q1 / AM64x …
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ) Design Recommendations / Custom board hardware design – Queries regarding power architecture including PMIC

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: TPS65214 Tool/software: Hi TI Experts, I am designing custom board using AM62L. Can you provide your inputs on the supported power architecture when custom board design is configured for RTC…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62P: How to Fix Missing TIFSSTUB to enable Low Power Modes in Linux SDK 10.0/10.1?

    Anshu Madwesh
    Anshu Madwesh
    Part Number: AM62P Tool/software: I've successfully tested low power modes on AM62P using the default images. But I've tried to build my own U-Boot images, but now low power modes are not working. What is the cause and solution to this?
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ) Why is MMC1 powered by two different voltage supplies, VDDSHV1 and VDDSHV3 ?

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts, Could you confirm that the voltage domains are correct for the MMC1_SDCD and MMC1_SDWP pins? The datasheet shows both MMC0 and MMC2 as having all member pins bellowing to the same voltage domain.…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to address the gPTP Sync failure post reset recovery of CPSW in Ethenret Firmware?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Tool/software: After a CPSW reset recovery from ETHFW, gPTP fails to re-establish synchronization, impacting time-sensitive applications.
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Building and Booting an UBIFS-based Linux rootfs from OSPI NOR Flash using TI Processor SDK Linux v11.x Yocto Sources

    Andreas Dannenberg
    Andreas Dannenberg
    Part Number: SK-AM64B Other Parts Discussed in Thread: SK-AM62B Tool/software: Overview The TI SK-AM64B EVM has an on-board 64MB-sized OSPI Flash chip that can be used to boot the AM64x device from. The documentation associated with SDK v11.0 contains…
    • 4 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197891 Discussions
  • Discussion

    OMAP/Davinci System Integration using Linux Workshop: Materials Now Available! Locked

    304 views
    0 replies
    Started over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    Inaccurate data from ADS1278 to a PALO43 (with OMAP3530 in it) through an SPI bus 0 Locked

    539 views
    0 replies
    Started over 15 years ago
    by Ion Beza
  • Discussion

    Davinci/OMAP System Integration using Linux Workshop: Materials Now Available! Locked

    407 views
    0 replies
    Started over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    From beginner: MMC access in Code Composer Studio (OMAP-L137) 0 Locked

    1035 views
    15 replies
    Latest over 15 years ago
    by RIZUAN
  • Answered

    There is not the rated value of PLLM / PLLOUT in case of 375MHz. 0 Locked

    328 views
    3 replies
    Latest over 15 years ago
    by tlee
  • Suggested Answer

    Urgent!!! ACPY3_wait() function doesn't wait really 0 Locked

    349 views
    4 replies
    Latest over 15 years ago
    by Gunjan
  • Not Answered

    MJCP and MPEG4 in DM355 0 Locked

    423 views
    5 replies
    Latest over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    how can i use vicp lib to improve h.264 bp on dm6446? 0 Locked

    175 views
    3 replies
    Latest over 15 years ago
    by Paul.Yin
  • Answered

    MSGQ Link Error 0 Locked

    407 views
    2 replies
    Latest over 15 years ago
    by Dennis Nguyen
  • Not Answered

    OMAP L138 McBsp0 and McAsp0 using the PSPDRIVERS 0 Locked

    287 views
    0 replies
    Started over 15 years ago
    by Fernando Pimenta
  • Not Answered

    What part of DM365 program is built using CCS? 0 Locked

    247 views
    2 replies
    Latest over 15 years ago
    by Roman Gavrilov
  • Not Answered

    Building Arago file system 0 Locked

    987 views
    2 replies
    Latest over 15 years ago
    by Denys Dmytriyenko
  • Not Answered

    Audio processing with DSP on omap3530 0 Locked

    695 views
    0 replies
    Started over 15 years ago
    by Jean FAYE
  • Answered

    linker error building for 64x of OMAP 35x EVM board 0 Locked

    307 views
    2 replies
    Latest over 15 years ago
    by rmb_vector
  • Suggested Answer

    H.264 Codec Development on DM6467 1Ghz 0 Locked

    490 views
    5 replies
    Latest over 15 years ago
    by Iain Hunter
  • Answered

    Problem with MSGQ_get in Worker Thread 0 Locked

    1028 views
    10 replies
    Latest over 15 years ago
    by SNBANIK
  • Not Answered

    signal passthrough VC5505 0 Locked

    574 views
    2 replies
    Latest over 15 years ago
    by Juliane Huettl
  • Not Answered

    LCD LIDD 8bit mode? 0 Locked

    478 views
    4 replies
    Latest over 15 years ago
    by Roger
  • Answered

    Problem with Converting MPEG4 ASP to H.264 on DM365 0 Locked

    220 views
    2 replies
    Latest over 15 years ago
    by Yashwant Dutt
  • Not Answered

    GPIO read write 0 Locked

    455 views
    1 reply
    Latest over 15 years ago
    by Mario Raffin
<>