TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198113 Discussions
  • Answered

    PNS (Perceptual Noise Substitution) module of the AAC encode 0 Locked

    1145 views
    2 replies
    Latest over 15 years ago
    by ZHENGXU HUANG
  • Not Answered

    PLEASE READ FIRST: Linux Forum Usage Guidelines 0 Locked

    223 views
    0 replies
    Started over 15 years ago
    by Niclas
  • Suggested Answer

    [OMAP3530] flash programing on new omap pop chip 0 Locked

    415 views
    1 reply
    Latest over 15 years ago
    by doron sandroy
  • Not Answered

    OMAPL138: GIT linux compiled error 0 Locked

    275 views
    1 reply
    Latest over 15 years ago
    by Sekhar Nori
  • Answered

    Wrong values when adding .cdb file 0 Locked

    306 views
    3 replies
    Latest over 15 years ago
    by Karl Wechsler
  • Not Answered

    mvl_4_0_1 download. 0 Locked

    495 views
    1 reply
    Latest over 15 years ago
    by Bernie Thompson TI
  • Answered

    DSP/BIOS Link debugging GPP application on Linux 0 Locked

    519 views
    3 replies
    Latest over 15 years ago
    by Deepali Uppal
  • Not Answered

    How to Change DSPLink memory map 0 Locked

    248 views
    1 reply
    Latest over 15 years ago
    by Deepali Uppal
  • Answered

    DSP/BIOS LINK API guide 0 Locked

    323 views
    3 replies
    Latest over 15 years ago
    by Deepali Uppal
  • Answered

    how to use the SHARED RAM on C6747 0 Locked

    689 views
    4 replies
    Latest over 15 years ago
    by zhangyg44396
  • Answered

    Using McBSP bitfield definitions causes unpredicable behavior 0 Locked

    619 views
    6 replies
    Latest over 15 years ago
    by Roger
  • Not Answered

    filter program 0 Locked

    284 views
    8 replies
    Latest over 15 years ago
    by Geza Anders
  • Not Answered

    XDS510 USB emulator 0 Locked

    347 views
    4 replies
    Latest over 15 years ago
    by Sid
  • Not Answered

    How to rebuild ti.rtdx package? 0 Locked

    321 views
    0 replies
    Started over 15 years ago
    by Ja Maitan
  • Not Answered

    Recommended Linux setup for DSP applications on Overo? 0 Locked

    163 views
    0 replies
    Started over 15 years ago
    by Michael Price
  • Answered

    Pointers problem 0 Locked

    253 views
    5 replies
    Latest over 15 years ago
    by Mark Moldavsky
  • Answered

    [OMAP-L137] linking in CMEM library in DSPLINK based app. 0 Locked

    436 views
    4 replies
    Latest over 15 years ago
    by Richard Bagdazian
  • Discussion

    reply to Bernie Thompson in TMS320DM355 Processors Locked

    421 views
    4 replies
    Latest over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    EDMA3 Resource Manager purpose 0 Locked

    373 views
    3 replies
    Latest over 15 years ago
    by Gunjan
  • Answered

    Codec Engine on C6747? 0 Locked

    731 views
    8 replies
    Latest over 15 years ago
    by David Kelly
<>