Part Number: TDA4VM Other Parts Discussed in Thread: DRA821 The DDR is configured by R5 SPL/SBL. Is there a way to check the frequency of DDR from Linux at runtime?

The following development guides are now available in Chinese: Software Guide: https://software-dl.ti.com/C2000/docs/software_guide_zh/index.html Optimization Guide: https://software-dl.ti.com/C2000/docs/optimization_guide_zh/index.html CLA SW…

Part Number: SN74HCS00 The Logic Industry’s Smallest Leaded Package; SOT-23-THIN (DYY) Many companies still rely solely on optical verification methods to ensure their components have been successfully soldered and are unwilling or not yet able to…

Part Number: MCU-PLUS-SDK-AM261X Hello Experts, I need to implement a standalone EtherCAT MDevice(MainDevice) on TI AM2x series MCU devices . My issue is where will i get a master stack to run on it? Also will there be some sample MDevice stack…

I’m working on customer board porting, and want to know how to modify QSPI/OSPI flash layout for SPL/u-boot booting from QSPI/OSPI with TI AM64x Linux SDK.

eMMC flash and boot work as expected on AM62x-SK E2 board from Power-On-Reset (POR), but an issue as listed below is observed on AM62x-SK E2. The Issue observed After successful eMMC boot from cold POR, WARM RESET options as listed below doesn’t re-boot…

Part Number: WL1837MOD This new release includes both firmware and driver updates. Firmware repo: https://git.ti.com/cgit/wilink8-wlan/wl18xx_fw/ Driver: Commit: https://git.ti.com/cgit/wilink8-wlan/build-utilites/commit/?h=r8.8&id=7a344003463805161cbbc892f65e52a8c3afab15…

There are four different types of resets available on a TI Ethernet PHY, each with it's own use case. Pin Reset: Activated by asserting the Reset pin low. Digital core is reset, link up process will restart. All internal registers will reinitialize…

Part Number: AM625 Hi, my customer has a question about using an output from the TPS6593 PMIC + a FET to control ON/OFF for 1.8V VPP on the processor? They are trying to see if they can get by without using a dedicated LDO for 1.8V VPP.

Other Parts Discussed in Thread: TCAN1043A-Q1 Introduction Any CAN transceiver that has an Inhibit (INH) pin will also have a sleep mode. The purpose of the INH pin is to be able to automatically turn off the voltage regulator for your MCU/Board. This…