Part Number: TDA4VM Other Parts Discussed in Thread: SYSCONFIG Hello, Now we are working on PSDK RTOS 7.3 1. We want to open more UDMA channels on MCU2_0 & MCU2_1 by calling app_udma utility API. But unfortunately that we can open only 3 UDMA channels…

This FAQ is no longer up-to-date. T he arbitration delay information on this page should no longer be used as a reference. For the latest information, refer to [FAQ] PRU Read & Write Latencies [FAQ] PRU Arbitration Delay I am writing a PRU application…

Part Number: LM4040-N Other Parts Discussed in Thread: LM4050-N Can you provide the part number nomenclature for LM4040-N and LM4050-N?

Part Number: TPS650330-Q1 Other Parts Discussed in Thread: TPS650320-Q1 This thread applies to the TPS650320-Q1 and TPS65033x-Q1: Find available part numbers for a variety of popular image sensors in the Camera PMIC Spin Selection Guide: https:…

Part Number: 66AK2E05 Hi, How to calculate the "DDR3 Interface – Registers" for Keystone II devices and Test/Debug on Keystone II EVM ?

Other Parts Discussed in Thread: UNIFLASH , C2000WARE This FAQ is aimed at using the TI C2000 Flash tools - CCS Flash plugin and UniFlash. This FAQ is applicable for F28M35x, F28M36x, F2837xD, F2837xS, F2807x, F28004x, F28002x, F2838x, F28003x. 1) How…

Other Parts Discussed in Thread: UCC27524 , UCC27624 , LMG1020 , UCC27712-Q1 , UCC27712 , UCC27282 , UCC21530-Q1 , UCC28704 , UCC21732 , UCC23513 Gate Driver FAQ – Frequently Asked Questions: High Power Gate Drivers – What are the benefits? TI’s wide…

Definitions: TX_DATA[3:0], TX_CLK (naming of TI Ethernet PHYs) are transmitted by the MAC/(Repeater PHY) and RX_DATA[3:0], RX_CLK (naming of TI Ethernet PHYs) are transmitted by Ethernet PHY. S.No Mode Definition 1 PHY: RX Align…

Other Parts Discussed in Thread: TLV9162 , TLV9152 Battery test applications require voltage accuracy of 0.01% or 100 ppm of the full-scale range after system calibration. General-purpose amplifiers with 1 µV/ °C input offset drift can easily meet this…

Part Number: TDA4VM Is I2C Fast Mode Plus supported on TDA4VM? What value of pullup resistor should be used on the I2C Open Drain SCL and SDA lines in Fast Mode Plus mode?