Part Number: TMDSOSKL137 Other Parts Discussed in Thread: TMS320C6747 Tool/software: Hello Experts, Customer get TMDSOSKL137, however there is not AC adaptor. Would you tell what type of AC adaptor should prepare to evaluate this EVM? Also would you provide…
Hi Alex,
Thank you, forward question
With what HW should I use to connect between our embedded board with the CC's SoM ICs and the printed PCB antenna to the PC SmartRF Studio,
I noticed the EVM / Expansion board is hard to get.
Can it be simple connected…
Hello Nathan,
Please see the EVM Users guide , the JTAG connection is on the underside of the EVM,
If still attached to the LCD screen, you might need to remove it. You might need some JTAG adaptors.
I don't believe there is any ethernet/JTAG functionality…
(SW1.1~1.8= 10000000)
Did't insert any jumpers on the EVM board
Tablet -> USB micro wire -> TUSB320 -> typeC adaptor with TYPE A connector -> USB flash
Red LED is lighting that indicate EVM is host with Tablet, USB should be slave and…
Hi Rob,
I haven't the ADC3669EVM board yet. I am thinking about buying it. I need to know the pinning of the FMC connector due to the connection to my FPGA board SP701. The description of the FMC connector is not in the User's Guide, and the schematic…
Good day Jesse,
Thanks for the input.
Yes, we are attempting to interface between windows PC and TPS8804EVM with USB2ANY and we followed procedure @
Using the TPS8804EVM (Rev. A)
Once connected USB2ANY adaptor, we are getting below message (Enclosed snaps…
Hi,
In order to use BQStudio to do I2C communications with the EVM, EV2300 or EV2400 is needed. If not using EV2300/EV2400, you have to use your own I2C adaptor with your own firmware.
Thanks,
Ning
Part Number: BQ76942EVM Other Parts Discussed in Thread: BQ76942 , EV2400 Tool/software: Dear Ti,
we are using BQ76942EVM , and tried to connect with Battery management studio. It Shows Auto detected : None and lands me to device selection, where selecting…
Hello Emad,
-1- If you are using a MIPI-60 interface for trace their are two VREF pins, one for trace pins and one for jtag pins. The value at each VREF will follow how the pin group is setup for the SOC. Both IO groups can take values of 1.8v or 3.3v…