Part Number: TL072 Other Parts Discussed in Thread: TL074H , TPA3116D2 , TLV9054 Hi,
A problem in the attached circuit is the pop noise, that is heard in the speakers at the output of IC1, received at its input, perhaps from the incorrect design in AC. …
Part Number: TL072 Hi,
The attached circuit is designed for a power supply of 9 volts, and the power supply of the class D amplifier, TPA3251D2 is 26 volts. Can I use 26 volts without conversion (down to 9 volts) to power the preamp with some changes…
Part Number: TL072 Hi
Could you advise difference between following 2 items?
Part# TL072MJG & TL072MJGB
What does ending "B" mean if the two items are the same?
Please advise.
Thank you.
Part Number: TL072 Greetings,
I'm using tl072ip in a voltage follower as a TTL buffer.
The chip is powered by a 30V single supply.
The output during duty+ periods is correct, but not for duty- period.
During duty- periods, the value of the output…
Part Number: LM2904 Other Parts Discussed in Thread: TL072 Hi team,
There is a design with the LM2904+TL072 in below.
VG1 is a 0 to 15V square wave @732Hz.
VM3 is the output but with a 500KHz signal on it as below test waveform.
We didn't see the phe…
Hi Patrick,
Agreed with Clemens - if they are from an authorized distributor, they are likely real TI devices.
Can you describe more about the problem? Do you have a problem with both 2227 and TL072?
Regards, Mike
Part Number: TL072 Other Parts Discussed in Thread: TINA-TI Tool/software: WEBENCH® Design Tools Hi Team,
My customer wants to use TINA to simulate the TL072, only find the PSpice model in ti.com.
How to import the PSpice model to Tina?
Thank you.
Best…
Part Number: SE555 Other Parts Discussed in Thread: LM358 , , TL072 I have been made aware that the place where I make my PCB's might be using non TI parts when TI parts, in specific, have been chosen and selected.
I went through most of my TI opamps…
Part Number: TL072 Other Parts Discussed in Thread: TL082 Hello -
In a small amplifier circuit I have designed, I am reliably getting 10dB more noise on the FFT when using the TL072CP as opposed to TL072IP. In the data sheet I can only see a few small…
Part Number: TL072 I have wired the circuit as a voltage follower not sure what is wrong, the output voltage is near to supply rails, in simulated i have got what ever is at the input terminal of non inverting i have got the same voltage at the output…