TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS7953 - trouble reading data 0 Locked

    2319 views
    8 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    Why my DAC2904-EVM does not have analog output? 0 Locked

    640 views
    9 replies
    Latest over 15 years ago
    by Hamza Fraz
  • Answered

    system/self calibration for ADS1243 0 Locked

    548 views
    2 replies
    Latest over 15 years ago
    by jack meng
  • Answered

    New to Data Conversion and need some help! ADS6422 interfacing. 0 Locked

    1186 views
    6 replies
    Latest over 15 years ago
    by Richard Prentice
  • Answered

    ADS1278 to OMAP3530 via SPI 0 Locked

    611 views
    2 replies
    Latest over 15 years ago
    by John Thomas43830
  • Answered

    Internal or External SCLK for SAR ADC 0 Locked

    537 views
    2 replies
    Latest over 15 years ago
    by Frank Huang16969
  • Answered

    ADS930 Tri State Outputs. 0 Locked

    537 views
    4 replies
    Latest over 15 years ago
    by martin b
  • Answered

    Connect ADS1248EVM on MMB0 0 Locked

    353 views
    2 replies
    Latest over 15 years ago
    by BOUQUET Hugo
  • Answered

    ADC Maximum Operating Temperatures 0 Locked

    923 views
    4 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    REF5025 vs TLE2425 0 Locked

    630 views
    2 replies
    Latest over 15 years ago
    by Stephanie Johnson
  • Answered

    problem I2C with ADS1114/15 0 Locked

    1711 views
    2 replies
    Latest over 15 years ago
    by Juan Maria
  • Answered

    SCLK serial output clock on ads1278 what option would work with a ftdi USB out chip to interface to the ads1278 0 Locked

    495 views
    1 reply
    Latest over 15 years ago
    by Kris F
  • Answered

    Would it be possible and sugjestable to use a 3.3v supply and power the ads1278 with it? 0 Locked

    494 views
    2 replies
    Latest over 15 years ago
    by Tony Calabria
  • Answered

    Design with ADS 8342 0 Locked

    686 views
    7 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    Any noise reduction trick for ADS1243 in reading squarewave AC bridge? 0 Locked

    493 views
    2 replies
    Latest over 15 years ago
    by fbj
  • Answered

    DAC5652 0 Locked

    412 views
    1 reply
    Latest over 15 years ago
    by Hamza Fraz
  • Answered

    ADS7861/ADS1251 all synchronously sampling 0 Locked

    907 views
    7 replies
    Latest over 15 years ago
    by Rick Downs - WEBENCH Design Center
  • Answered

    ADC for undersampling 0 Locked

    2656 views
    7 replies
    Latest over 15 years ago
    by Thomas Neu
  • Answered

    ADS1278 Voltage reference positive data sheet interpretation. 0 Locked

    880 views
    5 replies
    Latest over 15 years ago
    by Rick Downs - WEBENCH Design Center
  • Answered

    THS3091 (TSW3070) full scale step response question 0 Locked

    406 views
    1 reply
    Latest over 15 years ago
    by Hamza Fraz
<>