TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    [FAQ] Have a question about ADCs? Click here for FAQs, resources, and more! 0 Locked

    12808 views
    1 reply
    Latest over 3 years ago
    by Cole Macias
  • Not Answered

    DAC8562TEVM: DAC8562TEVM: digital glitches at the analog output 0

    17 views
    1 reply
    Latest 25 minutes ago
    by Paul_Frost
  • Answered

    ADS127L18: Calibration register adjustment range 0

    41 views
    3 replies
    Latest 34 minutes ago
    by TonyMCC
  • Not Answered

    DAC38RF83: JESD Alarm 0

    18 views
    1 reply
    Latest 5 hours ago
    by Ohad Bonneh
  • Not Answered

    DAC80502-01EVM: DAC80502-01 EVM can't write 0

    46 views
    4 replies
    Latest 6 hours ago
    by Brian Chan
  • Not Answered

    ADS8568: ADS8568SPM AD Acquisition Fault Description 0

    9 views
    1 reply
    Latest 6 hours ago
    by ian wu
  • Not Answered

    ADS9810: Technical Difference between different ADS98 series parts 0

    14 views
    0 replies
    Started 6 hours ago
    by Sahil Nayak
  • Not Answered

    ADC3222: Input clock amplitude for single end input 0

    9 views
    0 replies
    Started 6 hours ago
    by Shota Mago
  • Suggested Answer

    ADC3564: Clarification on ADC3564 Configuration and Datasheet Inconsistencies 0

    424 views
    21 replies
    Latest 9 hours ago
    by VINAYAKA JADAR
  • Not Answered

    DAC61416: Frame Error Checking Time / from CS signal to ALMOUT signal 0

    39 views
    3 replies
    Latest 10 hours ago
    by Sanjay
  • Suggested Answer

    ADS1292RECG-FE: appication issue. 0

    77 views
    4 replies
    Latest 11 hours ago
    by lang gao
  • Suggested Answer

    ADS1292RECG-FE: GUI installation issue 0

    34 views
    2 replies
    Latest 11 hours ago
    by Ryan Andrews
  • Answered

    ADS1299: About turning off AVDD and AVSS when inputting DVDD 0

    29 views
    1 reply
    Latest 12 hours ago
    by Ryan Andrews
  • Not Answered

    ADS7066: Inquiry Regarding ADC Malfunction 0

    24 views
    1 reply
    Latest 13 hours ago
    by Conor
  • Not Answered

    TSW14J50EVM: TSW14J50EVM Consultation on Usage Issues 0

    47 views
    3 replies
    Latest 14 hours ago
    by yingjiao LI
  • Suggested Answer

    ADC168M102R-SEP: What is recommended termination for CS', CLOCK, BUSY, SDI, RD, SDOA, SDOB, CONVST? 0

    25 views
    1 reply
    Latest 14 hours ago
    by Joel Meraz
  • Suggested Answer

    ADS124S06: ADS124S06 0

    398 views
    16 replies
    Latest 15 hours ago
    by Bosco N
  • Answered

    ADS124S06: ADS124S06 is stuck when RTD is floating. 0

    366 views
    19 replies
    Latest 15 hours ago
    by Bryan Lizon86
  • Answered

    ADS124S08: ADC Front End Design using ADS124S08 is Not Resilient to Industrial Noise, performs worse than prior generation design 0

    298 views
    20 replies
    Latest 15 hours ago
    by Bryan Lizon86
  • Not Answered

    AFE4490: Abnormal TX_REF value 0

    45 views
    3 replies
    Latest 16 hours ago
    by Payton Schubel
>