TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TLC2558: TLC2558 I 0 Locked

    811 views
    24 replies
    Latest over 5 years ago
    by user6252972
  • Answered

    ADS8686SEVM-PDK: need GUI software 0 Locked

    773 views
    10 replies
    Latest over 5 years ago
    by Cynthia
  • Answered

    ADS8332: Can not read Data / Just get "FFFF" 0 Locked

    1992 views
    7 replies
    Latest over 5 years ago
    by Keith Nicholas
  • Suggested Answer

    ADS62P49: Expected output mismatch in LVDS vs parallel CMOS Mode 0 Locked

    808 views
    7 replies
    Latest over 5 years ago
    by prem dubey
  • Suggested Answer

    AMC7836: Negative Supply Voltage 0 Locked

    210 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Answered

    DAC8775: Can it handle a load of 500 ohms? 0 Locked

    196 views
    1 reply
    Latest over 5 years ago
    by Kevin Duke
  • Suggested Answer

    DAC5662: Settling time 0 Locked

    302 views
    1 reply
    Latest over 5 years ago
    by RJ Hopper
  • Answered

    ADS1298R: Respiration signal submerged in 100Hz noise, when the electrode is put on human body 0 Locked

    1398 views
    13 replies
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    ADS1248: Ads1248 temperature convert formula 0 Locked

    637 views
    13 replies
    Latest over 5 years ago
    by mandha amarr
  • Answered

    ADS54J20EVM: power 3.3V of ADS54J20EVM 0 Locked

    412 views
    2 replies
    Latest over 5 years ago
    by suy
  • Answered

    ADS131E08: are there any clamp diodes at the analog input pins? 0 Locked

    536 views
    4 replies
    Latest over 5 years ago
    by Joseph Wu
  • Answered

    AFE5818EVM: HMC-DAQ GUI reset and initialize error 0 Locked

    1311 views
    26 replies
    Latest over 5 years ago
    by Chen Kung
  • Suggested Answer

    ADS124S08: Coefficient of thermal expansion 0 Locked

    207 views
    1 reply
    Latest over 5 years ago
    by Bob Benjamin
  • Suggested Answer

    DAC3154EVM: Getting simple output from board. 0 Locked

    484 views
    6 replies
    Latest over 5 years ago
    by RJ Hopper
  • Answered

    ADS5401: Undersampling for ADC 0 Locked

    401 views
    1 reply
    Latest over 5 years ago
    by RJ Hopper
  • Suggested Answer

    ADS8900BEVM-PDK: EVK user guide says data can be exported to text file, but it exports to a binary instead 0 Locked

    327 views
    1 reply
    Latest over 5 years ago
    by Keith Nicholas
  • Answered

    TSW14J56EVM: TSW14J56EVM 0 Locked

    370 views
    4 replies
    Latest over 5 years ago
    by Giora Eytan
  • Not Answered

    ADS1292: One lead ecg better CMRR OPA2188 and ADS1292 . 0 Locked

    333 views
    1 reply
    Latest over 5 years ago
    by Ryan Andrews
  • Suggested Answer

    DAC38RF82EVM: DAC board no output 0 Locked

    289 views
    1 reply
    Latest over 5 years ago
    by jim s
  • Answered

    ADC128S102: ADC128S102 reading problem when switching between channels (for me too) 0 Locked

    1346 views
    7 replies
    Latest over 5 years ago
    by user1341394
<>