TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS8509: min time for busy signal 0 Locked

    535 views
    9 replies
    Latest over 5 years ago
    by Dale Li
  • Answered

    ADS54J60: the difference ADS54J60 and ADS54J64 0 Locked

    390 views
    3 replies
    Latest over 5 years ago
    by suy
  • Suggested Answer

    TIPD166: How to increase the voltage range of TIPD166 to +/- 15v ? 0 Locked

    372 views
    1 reply
    Latest over 5 years ago
    by Dale Li
  • Suggested Answer

    ADS7142: Package 0 Locked

    239 views
    1 reply
    Latest over 5 years ago
    by Cynthia
  • Suggested Answer

    AFE5818: Register settings and reference materials 0 Locked

    509 views
    7 replies
    Latest over 5 years ago
    by Chen Kung
  • Suggested Answer

    ADS1220: Problem in short circuiting the differential inputs of the ADC 0 Locked

    766 views
    9 replies
    Latest over 5 years ago
    by Bob Benjamin
  • Answered

    ADC12DL3200: Letter Of Volatility 0 Locked

    303 views
    3 replies
    Latest over 5 years ago
    by jim s
  • Suggested Answer

    VSP5610: Generating a PWM output 0 Locked

    304 views
    1 reply
    Latest over 5 years ago
    by Praveen Aroul
  • Not Answered

    AFE4900EVM: AFE 4900 EVM 4th LED data 0 Locked

    338 views
    1 reply
    Latest over 5 years ago
    by Praveen Aroul
  • Not Answered

    AFE4900EVM: GUI acquisition tab, channel 4 (Ambient1) not capable of showing any signal 0 Locked

    201 views
    1 reply
    Latest over 5 years ago
    by Praveen Aroul
  • Answered

    ADS1299: Power Sequencing Digital and Analog Inputs 0 Locked

    298 views
    2 replies
    Latest over 5 years ago
    by Ryan Andrews
  • Suggested Answer

    Compiler/ADS1210: ADS1210,24-Bit ANALOG-TO-DIGITAL CONVERTER Chip, 0 Locked

    357 views
    1 reply
    Latest over 5 years ago
    by Bob Benjamin
  • Answered

    ADS1258-EP: ADS1258-EP 0 Locked

    507 views
    3 replies
    Latest over 5 years ago
    by Bryan Lizon86
  • Suggested Answer

    ADS4149EVM: ADS4149EVM schematic pinout for connector J10 does not match with HSMC-ADC-BRIDGE REV C schematic 0 Locked

    543 views
    1 reply
    Latest over 5 years ago
    by jim s
  • Answered

    ADS131A02: ADC responds to NULL Command with SPI fault after enabling the channels 0 Locked

    629 views
    2 replies
    Latest over 5 years ago
    by Katja Ehlen
  • Answered

    ADS1278-HT: Driving the ADC with a low bandwidth op amp - opa2333-HT 0 Locked

    690 views
    4 replies
    Latest over 5 years ago
    by John Smith
  • Not Answered

    ADS42LB69: ADS42LB69 one channel not working 0 Locked

    276 views
    2 replies
    Latest over 5 years ago
    by jim s
  • Suggested Answer

    ADC12J2700EVM: connected to a Xilinx Kintex Ulstrascale + KCU116 dev board 0 Locked

    2130 views
    39 replies
    Latest over 5 years ago
    by jim s
  • Suggested Answer

    ADS8588SEVM-PDK: REAL TIME CAPTURE 0 Locked

    472 views
    7 replies
    Latest over 5 years ago
    by Joseph Wu
  • Suggested Answer

    ADC12DJ3200: keeping the ADC in power down at Power Up 0 Locked

    336 views
    4 replies
    Latest over 5 years ago
    by Rob Reeder
<>