TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    VSP5610: Interfacing with FPGA Basys 3 board 0 Locked

    590 views
    3 replies
    Latest over 6 years ago
    by Praveen Aroul
  • Suggested Answer

    ADC128S102: ADC conversion time measurement 0 Locked

    552 views
    1 reply
    Latest over 6 years ago
    by Cynthia
  • Suggested Answer

    VSP5610: VHDL files for interfacing VSP5610 with Basys 3. 0 Locked

    333 views
    1 reply
    Latest over 6 years ago
    by Praveen Aroul
  • Suggested Answer

    VSP5610: Alternatives for VSP5610 0 Locked

    461 views
    1 reply
    Latest over 6 years ago
    by Praveen Aroul
  • Suggested Answer

    ADS7952: ADC sense 100R series resistance failure 0 Locked

    959 views
    1 reply
    Latest over 6 years ago
    by Cynthia
  • Suggested Answer

    AFE5808A: AFE5808A Frame Clk issue 0 Locked

    537 views
    7 replies
    Latest over 6 years ago
    by Chen Kung
  • Suggested Answer

    CCS/ADS1115: ads1115 0 Locked

    435 views
    2 replies
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS131E08: ADS131E08 0 Locked

    429 views
    2 replies
    Latest over 6 years ago
    by Joseph Wu
  • Answered

    ADS125H02: ideal Reference suggestion 0 Locked

    359 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Answered

    DDC114: Photodiode reverse bias 0 Locked

    1061 views
    4 replies
    Latest over 6 years ago
    by Eduardo Bartolome
  • Suggested Answer

    ADS1298ECGFE-PDK: WINDOWS 10 GUI Problem. 0 Locked

    280 views
    1 reply
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    ADC12DJ3200: Power supply desig for 3 ADCs 0 Locked

    876 views
    10 replies
    Latest over 6 years ago
    by LALIT VERMA
  • Answered

    DAC9881: Power-Supply Sequence 0 Locked

    592 views
    8 replies
    Latest over 6 years ago
    by itabi
  • Answered

    ADC12J1600EVM: FT_DEVICE_NOT_FOUND 0 Locked

    526 views
    3 replies
    Latest over 6 years ago
    by Francesco Raffaelli
  • Suggested Answer

    ADS1262: What happens when data rate is greater than 20 SPS and the FIR filter is selected 0 Locked

    313 views
    2 replies
    Latest over 6 years ago
    by Bernhard Kubicek
  • Suggested Answer

    ADS1013: The acquired value is fixed to the maximum value. 0 Locked

    471 views
    3 replies
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    AFE4490: Issue on AFE4490 start 0 Locked

    1299 views
    5 replies
    Latest over 6 years ago
    by Prabin Yadav
  • Suggested Answer

    ADC12DJ3200: Spur at Fs/2-Fin is too high that worsened the SFDR performance (Perhaps as well as SNR?) 0 Locked

    1237 views
    6 replies
    Latest over 6 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    ADC12DJ3200: Long latency between ADC and Kintex Ultrascale FPGA 0 Locked

    608 views
    2 replies
    Latest over 6 years ago
    by Jim Brinkhurst1
  • Answered

    TLA2024: ADC result is randomly a large number, though the corresponding input pin is empty 0 Locked

    309 views
    2 replies
    Latest over 6 years ago
    by QM Hou
<>