TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS7953: Misssing Codes 0 Locked

    760 views
    3 replies
    Latest over 6 years ago
    by Matthew Howorko
  • Answered

    ADS131E08: Low pass filter cut off frequency requirement analog front end with te ADS131E08 device. 0 Locked

    527 views
    1 reply
    Latest over 6 years ago
    by Joseph Wu
  • Answered

    ADS54J64: Power Consumption if used as single channel ADC 0 Locked

    253 views
    1 reply
    Latest over 6 years ago
    by jim s
  • Answered

    ADS7851: Data format mismatch between two pages of the datasheet 0 Locked

    375 views
    1 reply
    Latest over 6 years ago
    by Tom Hendrick
  • Not Answered

    TSW14J56EVM: TSW14J56EVM, HSDC Pro, and third party FX3 device 0 Locked

    611 views
    2 replies
    Latest over 6 years ago
    by Yusuf%20Agoro
  • Suggested Answer

    ADS1220 Zero Calibration Offset 0 Locked

    482 views
    2 replies
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS5294: ADS5294EVM 0 Locked

    578 views
    4 replies
    Latest over 6 years ago
    by Chen Kung
  • Answered

    AMC1204: What integrator time constant does the modulator have? 0 Locked

    352 views
    3 replies
    Latest over 6 years ago
    by Alexander Smith
  • Answered

    ADS124S06: ADS124S06 Digital Domain at PGA=64 and 128 0 Locked

    345 views
    2 replies
    Latest over 6 years ago
    by Masa Katayama
  • Answered

    ADS1256: When to enable the internal buffer and its effects on ADC performance 0 Locked

    1312 views
    1 reply
    Latest over 6 years ago
    by Christopher Hall
  • Answered

    ADS8671: ADS867x range switching time. 0 Locked

    590 views
    3 replies
    Latest over 6 years ago
    by alperen akk
  • Answered

    ADS7049-Q1: SCLK input timing requirement 0 Locked

    388 views
    2 replies
    Latest over 6 years ago
    by Shinya Sawamoto
  • Suggested Answer

    ADS1278: Code example 0 Locked

    1476 views
    1 reply
    Latest over 6 years ago
    by Keith Nicholas
  • Suggested Answer

    Compiler/ADS1298ECGFE-PDK: FFT results not matching with scope in ADS1298 ECG EVM 0 Locked

    627 views
    7 replies
    Latest over 6 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS1218: DYDY related issue. 0 Locked

    362 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Answered

    DAC7760: Can I use two DAC7760 on dual single +-V_SUP supply generated from TPS7A49, TPS7A30. 0 Locked

    425 views
    2 replies
    Latest over 6 years ago
    by Viraj Adam
  • Suggested Answer

    ADC12DJ3200EVM: ADC12DJ3200EVM 0 Locked

    544 views
    4 replies
    Latest over 6 years ago
    by Amnon Segal
  • Answered

    DAC39J84EVM: Missing EVM GUI software for DAC3xJ8xEVM 0 Locked

    466 views
    2 replies
    Latest over 6 years ago
    by jim s
  • Answered

    ADS1602: Harmonic at low frequency 0 Locked

    423 views
    4 replies
    Latest over 6 years ago
    by Yoshitaka Kotani
  • Suggested Answer

    ADC084S021: ADC084S021 example code 0 Locked

    421 views
    1 reply
    Latest over 6 years ago
    by Cynthia
<>