TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DAC8750: about current output accuracy 0 Locked

    292 views
    1 reply
    Latest over 7 years ago
    by Garrett Satterfield
  • Suggested Answer

    ADS131A04EVM: where to download the software and driver for this EVM (ADS131A04EVM)? 0 Locked

    653 views
    1 reply
    Latest over 7 years ago
    by Alexander Smith
  • Answered

    ADC34J45EVM: JESD clocks have not output 0 Locked

    756 views
    2 replies
    Latest over 7 years ago
    by dBrock
  • Answered

    DAC7811: Errata Survey 0 Locked

    261 views
    1 reply
    Latest over 7 years ago
    by Uttam Sahu
  • Answered

    ADS1158: Missing channels in Channel Data Read Command sequence 0 Locked

    843 views
    7 replies
    Latest over 7 years ago
    by Christopher Hall
  • Answered

    ADS1299: DRDY not always triggering 0 Locked

    1891 views
    5 replies
    Latest over 7 years ago
    by yf liu
  • Answered

    PLABS-SAR-EVM-PDK: GUI issue 0 Locked

    669 views
    4 replies
    Latest over 7 years ago
    by Sandeep Kasargod
  • Answered

    ADS124S06: DRDY signal issues 0 Locked

    574 views
    4 replies
    Latest over 7 years ago
    by Adrian Ymeraj
  • Answered

    ADS8588H: External ADC 0 Locked

    2242 views
    6 replies
    Latest over 7 years ago
    by Ramesh Palanisamy
  • Suggested Answer

    DDC112: Some wrong about my DDC112 data result,need your help! 0 Locked

    789 views
    3 replies
    Latest over 7 years ago
    by Praveen Aroul
  • Suggested Answer

    DDC112: why my DDC112 data fluction 0 Locked

    654 views
    1 reply
    Latest over 7 years ago
    by Praveen Aroul
  • Answered

    DDC11XEVM-PDK: please confirm the graph data at no signal 0 Locked

    1804 views
    15 replies
    Latest over 7 years ago
    by Shinichi Inoue
  • Answered

    ADC08060: Question regarding analog input range 0 Locked

    400 views
    2 replies
    Latest over 7 years ago
    by dBrock
  • Not Answered

    ADS131E08EVM-PDK: Input Seems Attenuated by a Factor of 2 and VREFP Doesn't Seem to be Supplied Internally 0 Locked

    1107 views
    6 replies
    Latest over 7 years ago
    by Ryan Andrews
  • Not Answered

    ADS1293EVM: ADS1293EVM: Problems with demo ADS1293EVM installing MSP430 0 Locked

    973 views
    4 replies
    Latest over 7 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS8688: ADS8688 Fail link with NB 0 Locked

    1228 views
    9 replies
    Latest over 7 years ago
    by Dale Li
  • Suggested Answer

    SM73201-ARC-EV: Information Regarding Regulatory Compliance for Testing 0 Locked

    376 views
    1 reply
    Latest over 7 years ago
    by Keith Nicholas
  • Answered

    ADS9110: twl_RST vs trst 0 Locked

    510 views
    2 replies
    Latest over 7 years ago
    by user5029136
  • Suggested Answer

    ADS1248: Problems with preset FSC values 0 Locked

    1849 views
    9 replies
    Latest over 7 years ago
    by Joseph Wu
  • Suggested Answer

    ADC for 10V load cell 0 Locked

    4318 views
    8 replies
    Latest over 7 years ago
    by Daniel Casale Linde
<>