TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS8557: Simultaneous sampling with External clock, best practices for jitter cleaning 0 Locked

    870 views
    2 replies
    Latest over 7 years ago
    by Alberto Carboni
  • Not Answered

    RCV420: 4-20 mA current loop receiver with multiple input channels 0 Locked

    616 views
    1 reply
    Latest over 7 years ago
    by Zak Kaye
  • Suggested Answer

    CCS/ADS1298ECGFE-PDK: Issue with ECG project build using CCS4 and ADS1298ECGSystem_v1.12 0 Locked

    638 views
    3 replies
    Latest over 7 years ago
    by AartiG
  • Suggested Answer

    DAC38RF80: 6.5Gb/s with QAM/CAP modulation on cat6a 0 Locked

    641 views
    2 replies
    Latest over 7 years ago
    by high speed guy
  • Suggested Answer

    ADS8900B: Api guide for ads8900b 0 Locked

    488 views
    1 reply
    Latest over 7 years ago
    by Bryan McKay
  • Suggested Answer

    ADS7828: Rds(resistance) at 8-Channel MUX 0 Locked

    716 views
    3 replies
    Latest over 7 years ago
    by Evan Sawyer
  • Answered

    ADS1282: calibrate gain ads1282 0 Locked

    1222 views
    5 replies
    Latest over 7 years ago
    by Christopher Hall
  • Answered

    ADS1115: ADS1115 ADC 0 Locked

    1881 views
    8 replies
    Latest over 7 years ago
    by Joseph Wu
  • Suggested Answer

    Linux/ADS1147: ESD, Burst Protection 5kV 0 Locked

    1383 views
    8 replies
    Latest over 7 years ago
    by Joseph Wu
  • Answered

    ADS1299EEGFE-PDK: Test Signals 0 Locked

    856 views
    4 replies
    Latest over 7 years ago
    by Matt Mendez
  • Suggested Answer

    ADS1292ECG-FE: Measuring ECG with 2 electrodes 0 Locked

    3732 views
    7 replies
    Latest over 7 years ago
    by Ryan Andrews
  • Answered

    ADS1262: External Reference Best Usage 0 Locked

    1076 views
    3 replies
    Latest over 7 years ago
    by Christopher Hall
  • Suggested Answer

    ADC12DJ3200: Tadj configuration 0 Locked

    484 views
    1 reply
    Latest over 7 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    ADS1298ECGFE-PDK: ads1298ECG-FE, voltage, Amplification 0 Locked

    829 views
    1 reply
    Latest over 7 years ago
    by Ryan Andrews
  • Not Answered

    DAC37J84: output frequency half what i was expecting 0 Locked

    485 views
    2 replies
    Latest over 7 years ago
    by jim s
  • Not Answered

    DAC904: E 0 Locked

    879 views
    3 replies
    Latest over 7 years ago
    by jim s
  • Answered

    ADS1271: Occasional errors in output data 0 Locked

    1022 views
    5 replies
    Latest over 7 years ago
    by Jan Burgemeister
  • Suggested Answer

    Linux: capacitive GT928 touch is not working in our custom AM3351 board 0 Locked

    3667 views
    1 reply
    Latest over 7 years ago
    by Pavel Botev
  • Answered

    ADS131A04: Frame fault after enabling ADCs, DRDY not going low 0 Locked

    2904 views
    6 replies
    Latest over 7 years ago
    by Henry Hinton
  • Not Answered

    ADC32J45: ADC32J45 INAP, INAM cross-connect? 0 Locked

    583 views
    1 reply
    Latest over 7 years ago
    by jim s
<>