TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADS7950-Q1: What is advantage of wide supply range ADC for Automotive? 0 Locked

    729 views
    2 replies
    Latest over 8 years ago
    by YJ Jo
  • Not Answered

    ADC32RF45: Behavioral RTL (VHDL or Verilog Model) 0 Locked

    968 views
    1 reply
    Latest over 8 years ago
    by Sourabh Gupta
  • Suggested Answer

    ADS54J42: Cannot configure the digital pages (6800, 6900 or 6A00) 0 Locked

    32226 views
    71 replies
    Latest over 8 years ago
    by Björn Langels
  • Not Answered

    TLV571: TLV571 with SWPWDN bit set in CR0 will not work (powerdown mode not Normal) 0 Locked

    3596 views
    13 replies
    Latest over 8 years ago
    by david patterson
  • Answered

    ADS1210: The calibration command issue timing 0 Locked

    498 views
    2 replies
    Latest over 8 years ago
    by Takumi Suzuki1
  • Answered

    ADS1210: Reset timing 0 Locked

    748 views
    2 replies
    Latest over 8 years ago
    by Takumi Suzuki1
  • Answered

    ADS1210: OCR and FCR 0 Locked

    621 views
    2 replies
    Latest over 8 years ago
    by Takumi Suzuki1
  • Not Answered

    TVP5150AM1: NTSC 3.58 not supported ? 0 Locked

    1335 views
    2 replies
    Latest over 8 years ago
    by ranchu
  • Suggested Answer

    ADS8568EVM-PDK: Can I get a FPGA source(Verilog) code for ads8568? 0 Locked

    1366 views
    5 replies
    Latest over 8 years ago
    by Dale Li
  • Suggested Answer

    ADC14X250EVM: Can I use lower frequency signal for the clock input than presented in the user's guide? 0 Locked

    944 views
    3 replies
    Latest over 8 years ago
    by Huioon Kim
  • Not Answered

    ADS1298: Getting wrong chip ID 7F 0 Locked

    1432 views
    3 replies
    Latest over 8 years ago
    by Ryan Andrews
  • Not Answered

    PGA411Q1EVM: Defective chip and a replacement needed 0 Locked

    447 views
    1 reply
    Latest over 8 years ago
    by Clancy Soehren
  • Answered

    ADS1293: SPI configuration mode 0 Locked

    1324 views
    1 reply
    Latest over 8 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS1675: Needs a Low-Jitter, 5V clock 0 Locked

    661 views
    1 reply
    Latest over 8 years ago
    by Ryan Andrews
  • Suggested Answer

    ADC14x250EVM: LMK04828 0 Locked

    1025 views
    3 replies
    Latest over 8 years ago
    by high speed guy
  • Not Answered

    Linux/ADS5263: Real noise floor of high speed data converters 0 Locked

    7014 views
    19 replies
    Latest over 8 years ago
    by Chen Kung
  • Not Answered

    THS8135: THS8135 on C6748 LC DEV KIT VER A7E 0 Locked

    1605 views
    2 replies
    Latest over 8 years ago
    by Michael C
  • Suggested Answer

    ADS7951: Max VREF (ABS max) 0 Locked

    1228 views
    6 replies
    Latest over 8 years ago
    by domenyko
  • Suggested Answer

    DAC8775: Finding the best DAC for an Industrial PLC application 0 Locked

    797 views
    5 replies
    Latest over 8 years ago
    by Matthew Sauceda
  • Answered

    DAC5672A: setup time and hold time 0 Locked

    1534 views
    3 replies
    Latest over 8 years ago
    by [FAE] Andrew Wang
<>