TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Discussion

    Need clarification on ADS1258 documentation; possible timing issue Locked

    276 views
    3 replies
    Latest over 15 years ago
    by Tony Calabria
  • Answered

    ADS1243 clarification 0 Locked

    514 views
    3 replies
    Latest over 15 years ago
    by Joseph Wu
  • Discussion

    ADS1271 timing Locked

    238 views
    1 reply
    Latest over 15 years ago
    by Tony Calabria
  • Discussion

    ADS1256 data corruption problems Locked

    287 views
    1 reply
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    Sampling high frequence narrow-bank signals with low sampling rate 0 Locked

    393 views
    4 replies
    Latest over 15 years ago
    by Philip Pratt
  • Answered

    ADS5542 It goes in power down and get out of it, but it doesn't give outputs at all 0 Locked

    411 views
    2 replies
    Latest over 15 years ago
    by Thomas Neu
  • Answered

    /DVALID 0 Locked

    600 views
    3 replies
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    TLV2556 input impedance 0 Locked

    367 views
    1 reply
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    ADS1298 ECG/EKG Analog Front End 0 Locked

    450 views
    1 reply
    Latest over 15 years ago
    by RudyeM
  • Answered

    Is OMAP2365 required to condition signal for ADS7863 (in pseudo differential mode). 0 Locked

    506 views
    1 reply
    Latest over 15 years ago
    by Tom Hendrick
  • Answered

    TVP5151 0 Locked

    435 views
    3 replies
    Latest over 15 years ago
    by James Nave
  • Discussion

    IMPACTRON - Build-in Thermistor Locked

    427 views
    0 replies
    Started over 15 years ago
    by hiro52788
  • Answered

    DAC5682EVM labview configuration code 0 Locked

    409 views
    3 replies
    Latest over 15 years ago
    by Hamza Fraz
  • Answered

    vertical line appear at the right side of display when input YCbCr, 20bits, 4:2:2 with embedded sync to THS8200 0 Locked

    616 views
    3 replies
    Latest over 15 years ago
    by Larry Taylor
  • Answered

    Test ADS1258 GPIOs 0 Locked

    503 views
    10 replies
    Latest over 15 years ago
    by Tony Calabria
  • Answered

    Resolution and SNR of the ADS1282 0 Locked

    323 views
    3 replies
    Latest over 15 years ago
    by RudyeM
  • Answered

    XDS510-USB2.0 0 Locked

    1950 views
    1 reply
    Latest over 15 years ago
    by Viet Dinh
  • Discussion

    How to drive CMG signal for IMPACTRON CCD Image Sensor. Locked

    419 views
    0 replies
    Started over 15 years ago
    by hiro52788
  • Answered

    TVP5150EVM register initialisation 0 Locked

    901 views
    7 replies
    Latest over 15 years ago
    by Larry Taylor
  • Answered

    ADS1255 data reading problem 0 Locked

    532 views
    1 reply
    Latest over 15 years ago
    by Tony Calabria
<>