TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS1278: Figure 88; What is the purpose of the flip flop? 0 Locked

    290 views
    1 reply
    Latest over 1 year ago
    by Keith Nicholas
  • Suggested Answer

    ADS54J40: Inquiry on how to calculate overall latency of ADS54J40 0 Locked

    402 views
    6 replies
    Latest over 1 year ago
    by Luke Allen
  • Not Answered

    DAC43401-Q1: Want to know the right register for my situation 0 Locked

    542 views
    13 replies
    Latest over 1 year ago
    by Katlynne Jones
  • Answered

    DAC7731: S/O: 218291 0 Locked

    334 views
    3 replies
    Latest over 1 year ago
    by Lucas Burnette
  • Not Answered

    DAC7311EVM: Where to download the drivers of MMB0 for windows 10 or above ? 0 Locked

    752 views
    3 replies
    Latest over 1 year ago
    by Katlynne Jones
  • Suggested Answer

    ADC081C021: Pull-up resistors for I2C 0 Locked

    243 views
    1 reply
    Latest over 1 year ago
    by Joel Meraz
  • Suggested Answer

    DAC43204: What is the input impedance of DAC43204? 0 Locked

    248 views
    1 reply
    Latest over 1 year ago
    by Katlynne Jones
  • Answered

    ADC08DJ3200EVM: ADCxxDJxx00 SPI Pins 0 Locked

    277 views
    3 replies
    Latest over 1 year ago
    by Chase W
  • Suggested Answer

    DAC63004W: FB pin Hi-Z in VOUT mode 0 Locked

    276 views
    1 reply
    Latest over 1 year ago
    by Katlynne Jones
  • Suggested Answer

    DAC8814: DAC8814 related issues 0 Locked

    281 views
    1 reply
    Latest over 1 year ago
    by Katlynne Jones
  • Suggested Answer

    TSW14DL3200EVM: FPGA Base Starter Project 0 Locked

    406 views
    3 replies
    Latest over 1 year ago
    by Dennis Bearden
  • Suggested Answer

    ADS124S08: PT1000 design requirements and selection of passive parts 0 Locked

    594 views
    1 reply
    Latest over 1 year ago
    by Bob Benjamin
  • Not Answered

    ANALOG-ENGINEER-CALC: ANALOG-ENGINEER-CALC Version 1.71 Blocked by Windows Defender 0 Locked

    533 views
    3 replies
    Latest over 1 year ago
    by Ron Michallick
  • Suggested Answer

    AMC1306E05: is there non-isolation device to propose? 0 Locked

    203 views
    1 reply
    Latest over 1 year ago
    by Saleh Ahmad
  • Suggested Answer

    DAC5675A-SP: Voltage level for driving the CLK pins single-ended 0 Locked

    301 views
    1 reply
    Latest over 1 year ago
    by Geoff Roth
  • Suggested Answer

    ADC34J45: About connection between Analog and Digital ground. 0 Locked

    309 views
    1 reply
    Latest over 1 year ago
    by Geoff Roth
  • Answered

    TPL0102-100: Potentiometer and a timer 0 Locked

    485 views
    5 replies
    Latest over 1 year ago
    by Farzaneh Faridi
  • Answered

    ADS127L11: Daisy-chain synchronization 0 Locked

    549 views
    3 replies
    Latest over 1 year ago
    by Jonas Martin
  • Answered

    ADS1220EVM: Can't Manually install the ADS1220EVM plugin in ADCpro 0 Locked

    612 views
    6 replies
    Latest over 1 year ago
    by Timo Zellmer
  • Not Answered

    AFE4960P: I wonder if there is a firmware binary code that the company provides for the AFE4960P and AFE4500 +1 Locked

    336 views
    0 replies
    Started over 1 year ago
    by KIKWAN KIM
<>