TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS8422: COMMOUT is 0.15 volts when REFOUT is 4.1V 0 Locked

    427 views
    2 replies
    Latest over 2 years ago
    by Mike C Detaille
  • Suggested Answer

    ADS1299-4: ESD diode need for ads1299 0 Locked

    335 views
    1 reply
    Latest over 2 years ago
    by ChienChun Yang
  • Answered

    ADS1294R: ADS1298ECGFE-PDK designs. 0 Locked

    288 views
    3 replies
    Latest over 2 years ago
    by ChienChun Yang
  • Answered

    XAD12DJ135 documentation 0 Locked

    440 views
    4 replies
    Latest over 2 years ago
    by Daniel Rozsnyo
  • Suggested Answer

    ADS5296A: ADS5296A - drive analog input 0 Locked

    326 views
    4 replies
    Latest over 2 years ago
    by Abhishek Vishwa1
  • Answered

    DAC12DL3200EVM: DAC12DL3200EVM USB is not connect and Occurin Error Message from GUI Program. 0 Locked

    690 views
    12 replies
    Latest over 2 years ago
    by Hyunsuk Lee
  • Suggested Answer

    DAC37J84EVM: dac37j84EVM 0 Locked

    348 views
    5 replies
    Latest over 2 years ago
    by Kang Hsia
  • Suggested Answer

    ESD Ratings (P/N: ADS1100 Series) 0 Locked

    210 views
    1 reply
    Latest over 2 years ago
    by Cynthia
  • Suggested Answer

    ADC081C021: I2C GUI 0 Locked

    235 views
    1 reply
    Latest over 2 years ago
    by Cynthia
  • Answered

    Counter for Digital input events 0 Locked

    151 views
    1 reply
    Latest over 2 years ago
    by Cynthia
  • Answered

    ADC12DJ2700: Packing of ADC12DJ2700 0 Locked

    183 views
    1 reply
    Latest over 2 years ago
    by Neeraj Gill
  • Suggested Answer

    DAC161P997: Suggestion to use 4 DAC161P997 in a single system with Common 24V Loop+ 0 Locked

    212 views
    1 reply
    Latest over 2 years ago
    by Paul_Frost
  • Suggested Answer

    DAC161P997: DAC161P997: Suggestion to use 4 - DAC161P997 in a single system with Common 24V Loop+ 0 Locked

    266 views
    1 reply
    Latest over 2 years ago
    by Paul_Frost
  • Suggested Answer

    ADS131M02: ADS131M02 converter 0 Locked

    249 views
    1 reply
    Latest over 2 years ago
    by Cole Macias
  • Suggested Answer

    ADS131A04EVM: Error data rate above 42,7kSPS 0 Locked

    195 views
    3 replies
    Latest over 2 years ago
    by Ryan Andrews
  • Answered

    ADS124S08: Common and Differential Input Impedance for the Mux/PGA 0 Locked

    278 views
    1 reply
    Latest over 2 years ago
    by Bob Benjamin
  • Answered

    AFE4490SPO2EVM: DB9 oximetry reflective mode 0 Locked

    807 views
    3 replies
    Latest over 2 years ago
    by Nick Zahabizadeh
  • Answered

    ADS8355: The behavior when CS is high(sampling and conversion) but SCLK is toggling 0 Locked

    320 views
    1 reply
    Latest over 2 years ago
    by Aaron Estrada
  • Answered

    ADS1293: RC Filter 0 Locked

    312 views
    3 replies
    Latest over 2 years ago
    by ChienChun Yang
  • Suggested Answer

    TSW1400EVM: only 14 bits can be collected and the other bits are wrong 0 Locked

    259 views
    3 replies
    Latest over 2 years ago
    by Abhishek Vishwa1
<>