TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    Request ESD Suppressor for Gigabit Ethernet & USB2.0. 0 Locked

    950 views
    9 replies
    Latest over 4 years ago
    by Matt Smith
  • Suggested Answer

    DS125MB203: DS125MB203 how to set register for 10G-KR under IIC mode 0 Locked

    396 views
    5 replies
    Latest over 4 years ago
    by Nasser Mohammadi
  • Answered

    DP83822I: DP83822 vs TLK105 0 Locked

    415 views
    3 replies
    Latest over 4 years ago
    by Vikram Sharma
  • Suggested Answer

    HD3SS3411: Bias Resistor Size 0 Locked

    464 views
    5 replies
    Latest over 4 years ago
    by Brian Zhou
  • Suggested Answer

    Asking for the LVDS to TTL solution 0 Locked

    218 views
    1 reply
    Latest over 4 years ago
    by Hamzeh Jaradat
  • Suggested Answer

    TUSB4041I: Current rising when GRSTz is activated 0 Locked

    281 views
    1 reply
    Latest over 4 years ago
    by JMMN
  • Not Answered

    SN65HVD75: SN65HVD75DGKR 0 Locked

    364 views
    3 replies
    Latest over 4 years ago
    by Hao L
  • Not Answered

    DS90UH941AS-Q1: Schematic review 0 Locked

    254 views
    3 replies
    Latest over 4 years ago
    by Michael.Walker
  • Suggested Answer

    TS3USB221A-Q1: Host-Slave 0 Locked

    442 views
    1 reply
    Latest over 4 years ago
    by Malik Barton57
  • Suggested Answer

    HD3SS3220: Can I use this part to do DP daisy chain? 0 Locked

    316 views
    4 replies
    Latest over 4 years ago
    by Malik Barton57
  • Not Answered

    HD3SS3220: Currently, the 5g-evb project uses hd3ss3220irnht chip, and the OTG function is being verified 0 Locked

    802 views
    1 reply
    Latest over 4 years ago
    by Malik Barton57
  • Answered

    TPS25810: BC1.2 application 0 Locked

    281 views
    1 reply
    Latest over 4 years ago
    by Emma Hoying
  • Suggested Answer

    TUSB1002A: Location and Equalization 0 Locked

    355 views
    3 replies
    Latest over 4 years ago
    by Malik Barton57
  • Suggested Answer

    TPD6S300A: Unused pin should floating or connect to GND 0 Locked

    304 views
    1 reply
    Latest over 4 years ago
    by Emma Hoying
  • Answered

    THVD1550: Stub constraints? 0 Locked

    647 views
    6 replies
    Latest over 4 years ago
    by Paolo Brentegani
  • Answered

    THVD2410: Front end protection with no VCC supply 0 Locked

    319 views
    2 replies
    Latest over 4 years ago
    by Andrew Peek
  • Not Answered

    P82B96: TI Designs: TIDA-060013: Design for I2C range extension + SMBus battery 0 Locked

    1125 views
    3 replies
    Latest over 4 years ago
    by Igor Uchansky15
  • Not Answered

    DP83867E: XI input parameters (thread continuation) 0 Locked

    591 views
    19 replies
    Latest over 4 years ago
    by Jiri Zajicek
  • Answered

    TPS65988: VBUS no voltage. 0 Locked

    601 views
    14 replies
    Latest over 4 years ago
    by Bing Hwang
  • Suggested Answer

    DS160PR410: will de-emphasis influence link training? 0 Locked

    366 views
    5 replies
    Latest over 4 years ago
    by Howard Tu
<>