TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    SN65DSI84: DSI tuner questions 0 Locked

    608 views
    1 reply
    Latest over 5 years ago
    by Ikechukwu Anyiam
  • Suggested Answer

    SN65DSI83-Q1: Can not install the DSI Tuner 0 Locked

    478 views
    1 reply
    Latest over 5 years ago
    by Ikechukwu Anyiam
  • Answered

    USB 3.1Gen2 or 3.1 10G controller IC (PCIe G3 x1 included). 0 Locked

    312 views
    3 replies
    Latest over 5 years ago
    by Brian Zhou
  • Answered

    DS160PR410: Pin_11 and Pin_18 VREG internal construction 0 Locked

    181 views
    2 replies
    Latest over 5 years ago
    by Davor Glisic
  • Answered

    DS90UB936-Q1: Lock signal during pattern generator output 0 Locked

    270 views
    1 reply
    Latest over 5 years ago
    by Casey McCrea
  • Answered

    TCA9548A: Is there internal pull-up voltage for those pin didn't pulled up by resistor? 0 Locked

    845 views
    9 replies
    Latest over 5 years ago
    by Miguel Robertson
  • Suggested Answer

    SN65HVD31: SN65HVD31 config to haft duplex 2 wires communication 0 Locked

    1764 views
    1 reply
    Latest over 5 years ago
    by Miguel Robertson
  • Answered

    TUSB1046-DCI: Type C suitable controller / without controller configuration 0 Locked

    299 views
    1 reply
    Latest over 5 years ago
    by Malik Barton57
  • Not Answered

    TUSB9261: Seeing slower read speeds than write speeds on USB3.0 interface. 0 Locked

    228 views
    1 reply
    Latest over 5 years ago
    by Malik Barton57
  • Answered

    DS250DF230: Request the orcad lib file. 0 Locked

    236 views
    3 replies
    Latest over 5 years ago
    by Nasser Mohammadi
  • Suggested Answer

    TPS65982: TPS65982 setting issue: Can't process DR swap to DFP 0 Locked

    453 views
    10 replies
    Latest over 5 years ago
    by Kedar_Sirdeshpande
  • Answered

    DP83848I: DP83848 LED_ACT LED frequency control 0 Locked

    301 views
    1 reply
    Latest over 5 years ago
    by Vikram Sharma
  • Not Answered

    DP83869HM: DP83869 Strap configuration and Schematic review 0 Locked

    1297 views
    1 reply
    Latest over 5 years ago
    by Vikram Sharma
  • Answered

    DS90UB949A-Q1EVM: How to connect SMA connectors 0 Locked

    2821 views
    24 replies
    Latest over 5 years ago
    by Casey McCrea
  • Answered

    HD3SS6126EVM: Eagle SCH and BRD files 0 Locked

    486 views
    5 replies
    Latest over 5 years ago
    by user6353791
  • Answered

    XIO2001: Do you have any plan to develop or release Successor product? 0 Locked

    235 views
    2 replies
    Latest over 5 years ago
    by Ryo Sugita
  • Answered

    DS90UB954-Q1: DS90UB954's CSI0_THS_PREP&CSI0_THS_ZERO parameter 0 Locked

    249 views
    4 replies
    Latest over 5 years ago
    by user6259789
  • Answered

    TS5USBC41: does FLT signal work when output disabled? 0 Locked

    326 views
    1 reply
    Latest over 5 years ago
    by Brian Zhou
  • Suggested Answer

    TL16C552: The customer wants TL16C552FN sample, but there is only TL16C552AFN on the sample system. What is the difference between the two?Is it interoperable? 0 Locked

    317 views
    2 replies
    Latest over 5 years ago
    by BOBBY
  • Answered

    TPD12S016: Can CT_HPD pin can connect to VCCA? 0 Locked

    759 views
    5 replies
    Latest over 5 years ago
    by Neil Chen
<>