TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    Does the DS90UB941AS support two screens? 0 Locked

    197 views
    1 reply
    Latest over 6 years ago
    by Charley Cai
  • Suggested Answer

    DS90UB954-Q1: min-max latency of FC and BC GPIO 0 Locked

    210 views
    1 reply
    Latest over 6 years ago
    by Charley Cai
  • Answered

    Linux/DS90UB964-Q1: DS90UB964-Q1: About the pattern generator 0 Locked

    681 views
    6 replies
    Latest over 6 years ago
    by zhong
  • Answered

    TPD4S012: To correspond IEC61000-4-4 0 Locked

    375 views
    2 replies
    Latest over 6 years ago
    by cafain
  • Answered

    LVDS to MIPI CSI-2 bridge 0 Locked

    2592 views
    4 replies
    Latest over 6 years ago
    by Sepeedah Zadeh
  • Answered

    PCA9543A: Problems with PCA9543A implementation 0 Locked

    404 views
    4 replies
    Latest over 6 years ago
    by Kirk Festing
  • Suggested Answer

    TMDS181: Pin Settings - confirmation requested 0 Locked

    1192 views
    16 replies
    Latest over 6 years ago
    by David (ASIC) Liu
  • Suggested Answer

    DS90UB954-Q1: board.write question 0 Locked

    298 views
    1 reply
    Latest over 6 years ago
    by Vishy Viswanathan
  • Not Answered

    DP83867IR: No MDI I/F establish 0 Locked

    325 views
    3 replies
    Latest over 6 years ago
    by Oded Globerman
  • Suggested Answer

    TMDS181: Does TMDA181 supports AC TMDS input ? 0 Locked

    449 views
    4 replies
    Latest over 6 years ago
    by David (ASIC) Liu
  • Answered

    DS90CR287: Connection of DS90CR287&288A 0 Locked

    383 views
    1 reply
    Latest over 6 years ago
    by Ikechukwu Anyiam
  • Answered

    TCAN4550-Q1: How to force ECC single bit error 0 Locked

    799 views
    3 replies
    Latest over 6 years ago
    by QJ Wang
  • Suggested Answer

    THVD1510: Surge transients protection IEC 61000-4-5 0 Locked

    2100 views
    5 replies
    Latest over 6 years ago
    by Hao L
  • Suggested Answer

    TCAN1043-Q1: INH pin voltage stays HIGH after Vcc drops to 0V 0 Locked

    632 views
    3 replies
    Latest over 6 years ago
    by Eric Hackett
  • Answered

    SN75DPHY440SS: SN75DPHY440SS Max. datarate and supported clock mode 0 Locked

    1439 views
    6 replies
    Latest over 6 years ago
    by Ivo Ninive
  • Not Answered

    TS3USB221A: OTG required in one of the Port 0 Locked

    203 views
    1 reply
    Latest over 6 years ago
    by Brian Zhou
  • Suggested Answer

    HD3SS3411-Q1: Pin number 0 Locked

    238 views
    1 reply
    Latest over 6 years ago
    by Brian Zhou
  • Suggested Answer

    DS26LV32AT: BACKWARD COMPATIBILITY 0 Locked

    247 views
    1 reply
    Latest over 6 years ago
    by Hao L
  • Suggested Answer

    TUSB320-LA-EVM: Manufacturer USB Type-C connector 0 Locked

    401 views
    1 reply
    Latest over 6 years ago
    by David (ASIC) Liu
  • Suggested Answer

    TL852: From where I can download libraries for TL851 and TL852 to use them in proteus for simulation? 0 Locked

    417 views
    1 reply
    Latest over 6 years ago
    by Yaser Ibrahim
<>