TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    TPD2E2U06: Best selection for USB2.0 FS 0 Locked

    346 views
    1 reply
    Latest over 7 years ago
    by Cameron Phillips
  • Not Answered

    DP83867IR: back to normal process after WOL 0 Locked

    537 views
    2 replies
    Latest over 7 years ago
    by K.Hamamoto
  • Suggested Answer

    DS90UB949-Q1: Some questions about GPIOs of DS90UB949-Q1 with DS90UB948-Q1. 0 Locked

    640 views
    3 replies
    Latest over 7 years ago
    by Steven(Shenzhen) Shi
  • Suggested Answer

    DS90UB949-Q1: GPIO[3:0] pins can read automaticly without through local register. 0 Locked

    612 views
    6 replies
    Latest over 7 years ago
    by Went Cao
  • Answered

    LMH0387: Layout design : Relief under LMH0387 0 Locked

    1248 views
    2 replies
    Latest over 7 years ago
    by Kawai
  • Suggested Answer

    DS90UB953-Q1: Couple CAP rated voltage used by TX (UB953)and RX(UB954) 0 Locked

    1487 views
    16 replies
    Latest over 7 years ago
    by Steven(Shenzhen) Shi
  • Suggested Answer

    TPS65986: FLwd 0xFF return code 0 Locked

    545 views
    6 replies
    Latest over 7 years ago
    by Praneet Kumar
  • Answered

    Linux/TUSB8041: U1/U2 fail, can't read hub descriptor, Cannot set link state. 0 Locked

    7207 views
    9 replies
    Latest over 7 years ago
    by Dallas Chen
  • Answered

    DS90UB948-Q1: How to set register for passthrough data through serizlizer(929) and deserializer(948) 0 Locked

    505 views
    2 replies
    Latest over 7 years ago
    by user5302425
  • Answered

    UCC21520: RC filter for INA pin 0 Locked

    845 views
    5 replies
    Latest over 7 years ago
    by Derek Payne
  • Answered

    Linux/DP83620: Use DP83620 as fiber mode,could not ping 0 Locked

    3079 views
    15 replies
    Latest over 7 years ago
    by Rob Rodrigues
  • Answered

    HD3SS3212: Type-C protection 0 Locked

    368 views
    3 replies
    Latest over 7 years ago
    by Brian Zhou
  • Answered

    DP83849IF: Media Converter using DP83849IF 0 Locked

    423 views
    1 reply
    Latest over 7 years ago
    by Aniruddha Khadye
  • Suggested Answer

    DP83TC811R-Q1: DP83TC811R-Q1 AVB/TSN details document 0 Locked

    435 views
    1 reply
    Latest over 7 years ago
    by Aniruddha Khadye
  • Answered

    DS250DF410EVM: How to generate 24.33Gbps PRBS31 data out? 0 Locked

    644 views
    3 replies
    Latest over 7 years ago
    by Nasser Mohammadi
  • Answered

    DS280MB810: SAS4 and SATA support? 0 Locked

    644 views
    3 replies
    Latest over 7 years ago
    by Nasser Mohammadi
  • Suggested Answer

    TUSB544: TUSB544 DC Electrical Characteristics in I2C mode question 0 Locked

    420 views
    1 reply
    Latest over 7 years ago
    by Brian Zhou
  • Suggested Answer

    THVD1452: Question about current development status 0 Locked

    537 views
    1 reply
    Latest over 7 years ago
    by Miguel Robertson
  • Suggested Answer

    TUSB8041EVM: the TUSB8041 device would shut up,Why ? 0 Locked

    739 views
    5 replies
    Latest over 7 years ago
    by JMMN
  • Suggested Answer

    TCA6408A: TCA6408A 0 Locked

    423 views
    1 reply
    Latest over 7 years ago
    by BOBBY
<>