TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Logic

Logic

Logic forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask technical support questions on everything from voltage level translation and transceivers to standard logic gates and specialty logic devices. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How do I configure a monostable multivibrator's inputs for rising/falling edge triggering?

    Emrys Maier
    Emrys Maier
    Other Parts Discussed in Thread: SN74LVC1G123 FAQ: Logic and Voltage Translation > Monostable Multivibrators >> Current FAQ Logic function table for the SN74LVC1G123 Most monostable multivibrator (MMV) devices have very similar logic tables to…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] With Open-Drain outputs, can I ...use them to shift a logic voltage level? ...connect the outputs directly together? ...force a voltage node to zero?

    Emrys Maier
    Emrys Maier
    Other Parts Discussed in Thread: SN74LVC1G123 FAQ: Logic and Voltage Translation > Output Parameters >> Current FAQ The answer to all three questions is "yes" - these are the three primary uses of open-drain outputs on logic devices. Much of this also…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] Can I connect the Cext pin to ground on a monostable multivibrator?

    Emrys Maier
    Emrys Maier
    Other Parts Discussed in Thread: SN74LV221A , SN74LVC1G123 , SN74LV123A , SN74221 , SN74LS221 FAQ: Logic and Voltage Translation > Monostable Multivibrators >> Current FAQ For the majority of MMV devices, y es, the Cext pin can be grounded. The Cext…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] How do you determine the output pulse width and the 'K' value for a monostable multivibrator?

    Emrys Maier
    Emrys Maier
    FAQ: Logic and Voltage Translation > Monostable Multivibrators >> Current FAQ The output pulse width (tw) is determined with the following equation: tw = K * R * C with R := external timing resistor, C := external timing capacitor, K := timing constant…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] How do I terminate an unused channel of a monostable multivibrator (one shot)?

    Emrys Maier
    Emrys Maier
    Other Parts Discussed in Thread: SN74LV221A FAQ: Logic and Voltage Translation > Monostable Multivibrators >> Current FAQ Unused channels for a logic monostable multivibrator (MMV) such as the SN74LV221A should be terminated such that: (1) All inputs…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] How does a monostable multivibrator (one shot) work?

    Emrys Maier
    Emrys Maier
    FAQ: Logic and Voltage Translation > Monostable Multivibrators >> Current FAQ The above functional block diagram shows generally how a monostable multivibrator (MMV, or one-shot) works. Not all of them have every part shown, but this is the most common…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] What's the difference between TTL and 5V CMOS logic?

    Emrys Maier
    Emrys Maier
    FAQ: Logic and Voltage Translation > Logic Technology >> Current FAQ It's very common for people to refer to "TTL logic" and to actually mean "5V logic" -- but how are they different? The key difference is in the input and output voltages. This graphic…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] What is the difference in timing between gates in the same device? How much skew is expected within a given logic device? What is the part-to-part skew?

    Karan Kotadia
    Karan Kotadia
    FAQ: Logic and Voltage Translation > Timing Parameters >> Current FAQ The difference in delay between the individual channels on an individual part is referred to as channel-to-channel skew or output skew. This is typically not covered as a datasheet…
    • over 5 years ago
    • Logic
    • Logic forum
  • [FAQ] What is the difference between the SN74HCxx and the SN74HCxxA?

    Emrys Maier
    Emrys Maier
    Other Parts Discussed in Thread: SN7400 , SN74LS00 FAQ: Logic and Voltage Translation > Logic Technology >> Current FAQ The High-speed CMOS (HC) logic family was created as a direct replacement for older bipolar junction transistor based transistor…
    • over 6 years ago
    • Logic
    • Logic forum
  • [FAQ] What method is best used for estimating specification values between those given in the datasheet?

    Emrys Maier
    Emrys Maier
    FAQ: Logic and Voltage Translation > Input Parameters >> Current FAQ The most common example of this question comes from the fact that Standard Logic devices are specified at 1.65V, 3V, and 4.5V, however most engineers use our devices at 1.8V, 3.3V…
    • over 6 years ago
    • Logic
    • Logic forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    SMV512K32-SP: tAVWL Write Cycle Timing 0 Locked

    418 views
    1 reply
    Latest over 5 years ago
    by Jake Bettis1
  • Answered

    SN74LVC1G14: SN74LVC1G14: Datasheet Mismatch (Threshold Voltages) 0 Locked

    383 views
    1 reply
    Latest over 5 years ago
    by Dylan Hubbard
  • Answered

    SN74LV244A: How to Know Output Resistor Need 0 Locked

    495 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Answered

    Require TOP MARKING 0 Locked

    270 views
    1 reply
    Latest over 5 years ago
    by Ikechukwu Anyiam
  • Answered

    SN74LVC1G373: Trouble with status of Q output after power-up 0 Locked

    1193 views
    4 replies
    Latest over 5 years ago
    by sebastien salmon
  • Answered

    SN74LVC245A: SN74LVC245A in Mixed Voltage during Power-Up 0 Locked

    375 views
    1 reply
    Latest over 5 years ago
    by Chad Crosby
  • Suggested Answer

    SN54HC574: JM38510/65604BRA VS SNJ54HC574J 0 Locked

    295 views
    1 reply
    Latest over 5 years ago
    by Chad Crosby
  • Not Answered

    SN74LS02: Simulation issue: SN74LS02 gate rise- and fall-times depends on input frequency 0 Locked

    285 views
    1 reply
    Latest over 5 years ago
    by Chad Crosby
  • Not Answered

    TXS0102: about Level shifter TXS0102 for I2C signal 0 Locked

    2938 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Suggested Answer

    SN74AUP1T34: High to Low Voltage Translation 0 Locked

    301 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Suggested Answer

    SN74AUP1T34: Tying VCCA and A Pins 0 Locked

    317 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Suggested Answer

    LSF0204: If can be used for 1.8V LVCMOS level shifter 0 Locked

    261 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Suggested Answer

    SN74ALVCH162373: SN74ALVCH162373: SN74ALVCH162373 EOLA and finding recommended replacement 0 Locked

    324 views
    2 replies
    Latest over 5 years ago
    by Lee Chiew Teik
  • Not Answered

    CD74HC283: ESD spec(HBM/CDM) of CD74HC283M 0 Locked

    361 views
    2 replies
    Latest over 5 years ago
    by Masahiro Chino
  • Suggested Answer

    CD74HC4060: CD74HC4060m96 0 Locked

    565 views
    1 reply
    Latest over 5 years ago
    by Emrys Maier
  • Suggested Answer

    LSF0102: Design Question 0 Locked

    392 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Suggested Answer

    CD74HC132: Characterization data 0 Locked

    266 views
    1 reply
    Latest over 5 years ago
    by Emrys Maier
  • Suggested Answer

    Asking for the logic design suggestion 0 Locked

    355 views
    3 replies
    Latest over 5 years ago
    by Dylan Hubbard
  • Suggested Answer

    SN74LVC1G125-Q1: Datasheet question (over recommended spec) 0 Locked

    451 views
    1 reply
    Latest over 5 years ago
    by Clemens Ladisch
  • Suggested Answer

    LSF0204: Level Shifter Schematic Review 0 Locked

    513 views
    3 replies
    Latest over 5 years ago
    by Clemens Ladisch
<>