Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask technical support questions on everything from voltage level translation and transceivers to standard logic gates and specialty logic devices. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Other Parts Discussed in Thread: TS5A3159-Q1 , TMUX1209 FAQ: Logic and Voltage Translation > Logic Technology >> Current FAQ
Hi Team,
May I know difference is there between mux/demux IC's and analog switch IC's?
I'm comparing this in the context…
FAQ: Logic and Voltage Translation > Output Parameters >> Current FAQ
The high logic level output voltage of a logic device with no load will be the supply voltage.
The output current of a logic device is determined by the load connected to the device…
FAQ: Logic and Voltage Translation > Output Parameters >> Current FAQ
Transmission lines cause a lot of confusion for engineers. I hope to clear up some of that here. I will break this up into a few sections, so if you already know something you can…
FAQ: Logic and Voltage Translation > Output Parameters >> Current FAQ
**** It's important to note that this FAQ is in reference to CMOS devices. Bipolar devices should not be paralleled in this fashion. ****
The primary concern with connecting outputs…
FAQ: Logic and Voltage Translation > Logic Technology >> Current FAQ
The " Ioff " specification in the electrical characteristics table is only in the datasheet of devices that have the special feature of " partial power down " - also known as " back…
Other Parts Discussed in Thread: SN74LVC1G08 FAQ: Logic and Voltage Translation > Input Parameters >> Current FAQ
What is V IH and V IL ?
JEDEC - V IH min is the least positive (most negative) value of high-level input voltage for which operation…
Other Parts Discussed in Thread: SN74AUP1G34 FAQ: Logic and Voltage Translation > Input Parameters >> Current FAQ
Pull-up and pull-down resistors are required in many logic systems to provide a valid logic state when a wire connected to a CMOS input…
Other Parts Discussed in Thread: SN74LVC1G34 , SN74LVC1G79 FAQ: Logic and Voltage Translation > Timing Parameters >> Current FAQ
** NOTE **
This FAQ is in reference to push-pull output devices. Open-drain outputs will
inherently have slower operating…
FAQ: Logic and Voltage Translation > Output Parameters >> Current FAQ
There are circumstances where you might want to know a VOH or VOL Value that is not given. I will describe two cases:
If you want VOH for a supply voltage that is not given (for…
Other Parts Discussed in Thread: LSF0101 , LSF0002 , LSF0102 , LSF0204 , LSF0204D , LSF0108 , LSF0102-Q1 , LSF0204-Q1 , LSF0108-Q1 FAQ: Logic and Voltage Translation > Voltage Translators >> Current FAQ
The LSF family of translators generates more questions…
