Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask technical support questions on everything from voltage level translation and transceivers to standard logic gates and specialty logic devices. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
TXG devices (both push-pull and open-drain) cannot support any level of IEC-ESD. However, IEC-ESD can still be achieved by using a protection device like the ESDS30x product…
Other Parts Discussed in Thread: TXG8122-Q1
Since the I2C protocol limits the allowable bus capacitance to 400pF (for Standard and Fast Mode) or 550pF (for Fast Mode+), similar requirements will need to be implemented on the TXG8122-Q1.
There are…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
At the moment TXG QFN packages do not support wettable flanks. However, we are working towards supporting wettable flank packages once products are fully released.
The QFN…
Other Parts Discussed in Thread: TXG1041 FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
The leakage between two grounds can be found under the Electrical Characteristics section in the datasheet.
Using the TXG1041 datasheet…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
The TXG product family can be used as a regular level translator (VCCA > VCCB or VCCA < VCCB) or in a buffer configuration (VCCA = VCCB).
If a user doesn’t need ground shifting…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
The maximum trace length that ground-level translators (as well as logic devices) can drive is 60 mm. This is a safe trace length for most devices to drive across the majority…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
To use the ground shift capability, voltage supplies need to be separated and fall within the recommended operating conditions.
Let’s use the figure above as an example…
Other Parts Discussed in Thread: TXG8041
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
A negative signal can be generated from ground-level translators as long as the user’s system has a negative supply rail. To prevent…
FAQ: Logic and Voltage Translation > > Current FAQ
[FAQ] What are the differences between Ground-Level Translators and Digital Isolators?
[FAQ] Can I generate a negative PWM signal from a positive PWM signal?
[FAQ] Is DC ground shifting possible…
FAQ: Logic and Voltage Translation > Ground-Level Translators >> Current FAQ
Ground-Level Translators
Digital Isolators
GNDA to GNDB Difference
80V
3kVrms
Galvanic Barrier
No
Yes
GNDA to GNDB Leakage (VCC to GND…
