TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Why can the USB-PD-CHG-EVM-01 not be configured for a 1s battery?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: USB-PD-CHG-EVM-01 The TPS25750D requires 5V on PP5V in order to source 5V and for VCONN support. In the design of the board, we decided to supply the PP5V rail from a 5V buck converter. If a battery voltage less than or close to 5V were…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] What is the function of the MPPSET voltage on the BQ24650?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24650 The function of the BQ24650 MPPSET pin is to hold the input voltage (known as the Maximum Power Point Voltage) at a set point in the event that the input power drops. It is set as a voltage divider from the input to the MPPSET…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Can the EV2400 be used to communicate with the BQ25792 through BQSTUDIO on the board USB-PD-CHG-EVM-01?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: USB-PD-CHG-EVM-01 Other Parts Discussed in Thread: BQSTUDIO , BQ25792 , EV2400 Yes, the EV2400 and BQStudio can be used to communicate with the charger BQ25792. Please connect the EV2400 to the J7 header with the GND wire closest to…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How do I configure the TPS25750 and flash the EEPROM with the output binary for the board USB-PD-CHG-EVM-01?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: USB-PD-CHG-EVM-01 Other Parts Discussed in Thread: TPS25750 , Open the TPS25750 Application Customization Tool and … Select all of the desired PD controller and charger parameters. Select “Download Full Flash Binary.” Power the USB…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How is the input current limit determined for the BQ25882, BQ25883, BQ25886, and BQ25887 chargers?

    Angelo Zhang87
    Angelo Zhang87
    Other Parts Discussed in Thread: BQ25886 How do I set the input current limit for these chargers?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] How should the /BATPRES pin be connected on the following chargers: BQ24770, BQ24773, BQ24780S?

    Angelo Zhang87
    Angelo Zhang87
    Other Parts Discussed in Thread: BQ24780S What is the function of the charger's /BATPRES pin, and how should this pin be connected?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Do the following chargers have a termination current setting: BQ24715, BQ24725A, BQ24735, BQ24770, BQ24773, BQ24780S?

    Angelo Zhang87
    Angelo Zhang87
    Do these chargers have a termination current setting at which point the device terminates the charge cycle, or will the charge current taper all the way down to zero in CV (constant voltage) mode?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] Can the following chargers be used to charge smart batteries: BQ24715, BQ24725A, BQ24735, BQ24770, BQ24773, BQ24780S?

    Angelo Zhang87
    Angelo Zhang87
    Can these chargers be used to charge smart batteries? Are they SBS 1.1 compliant?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62901: How do you select the MODE/S-CONF pin resistor?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62901 What is the accepted resistor tolerance for the MODE/S-CONF pin resistor on the TPS6290x device? Can I use a value greater than 118k Ohm?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why VSYS does not start up normally when there is a loading on the SYS and the battery is not present for BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ25898C, BQ24190, BQ24192, BQ24192I, BQ24195, BQ24292I...

    Ning T
    Ning T
    Part Number: BQ25890 Other Parts Discussed in Thread: BQ24190 , BQ25898 , BQ24296 , BQ24192I , BQ25895 , BQ25896 , BQ24193 , BQ24192 , BQ24292I , , BQ24295 , BQ24298 , BQ25898C , BQ25898D , , BQ24259 , BQ25895M , BQ25892 , BQ24296M , BQ24195 , BQ24196…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TPS25751EVM: TPS25751-EVM 0 Locked

    265 views
    3 replies
    Latest over 1 year ago
    by Kevin Kosta
  • Answered

    LM27762: Line and load regulation at 3V and 2.7V 0 Locked

    255 views
    1 reply
    Latest over 1 year ago
    by Andreas Mueller
  • Suggested Answer

    BQ40Z50-R2: Please helps to identify the most appropriate chip selection 0 Locked

    189 views
    1 reply
    Latest over 1 year ago
    by Adrian
  • Suggested Answer

    TPS546D24A: PSPICE MODEL 0 Locked

    198 views
    1 reply
    Latest over 1 year ago
    by Tomoya Ide
  • Not Answered

    EV2400: EV2400 Cannot Communicate With My PC 0 Locked

    346 views
    2 replies
    Latest over 1 year ago
    by Jonny
  • Answered

    LM137QML-SP: How the PDmax @25oC is calculated as 2.5W? 0 Locked

    283 views
    1 reply
    Latest over 1 year ago
    by Sarah Koch
  • Suggested Answer

    BQ25798: Fails to immediately reinitiate charge if light level on the solar panel ever drops too low. 0 Locked

    272 views
    3 replies
    Latest over 1 year ago
    by Jeff F
  • Suggested Answer

    LM51551-Q1: Increasing the output caps to provide higher transient current 0 Locked

    539 views
    12 replies
    Latest over 1 year ago
    by Moritz
  • Suggested Answer

    TPS25750: leakage current issue 0 Locked

    1867 views
    51 replies
    Latest over 1 year ago
    by Christopher Lim1
  • Suggested Answer

    BQ25703A: Battery charger buck boost standalone 0 Locked

    363 views
    3 replies
    Latest over 1 year ago
    by Christian Moyer
  • Answered

    LP87523-Q1: Undocumented interrupt firing when reading GPIO_IN register 0 Locked

    288 views
    3 replies
    Latest over 1 year ago
    by Sarah Lao
  • Suggested Answer

    LM5109B-Q1: LM5109B-Q1 0 Locked

    229 views
    1 reply
    Latest over 1 year ago
    by Walter Zollinger
  • Suggested Answer

    UCC33420: Efficiency 0 Locked

    218 views
    1 reply
    Latest over 1 year ago
    by Manuel Alva Hernandez
  • Answered

    UCC27614: IN-, IN+ not referenced for GND 0 Locked

    337 views
    3 replies
    Latest over 1 year ago
    by Rubas Khalid
  • Suggested Answer

    TPS546B24A: Inductor saturation current 0 Locked

    204 views
    2 replies
    Latest over 1 year ago
    by Tomoya Ide
  • Not Answered

    BQ25638: Functionality of thermistor 0 Locked

    130 views
    0 replies
    Started over 1 year ago
    by BINYAMIN A
  • Suggested Answer

    UCC28950-Q1: 7KW PSFB Design 0 Locked

    380 views
    2 replies
    Latest over 1 year ago
    by Mike O'
  • Answered

    TPS65276V: Decoupling of V7V LDO 0 Locked

    321 views
    4 replies
    Latest over 1 year ago
    by Arnaud DAVY
  • Suggested Answer

    TPS7H5005-SEP: How do I use the TPS7H500X-SP family for single switch forward controller with synchronous secondary rectification? 0 Locked

    214 views
    1 reply
    Latest over 1 year ago
    by Daniel Hartung
  • Suggested Answer

    CSD86356Q5D: CSD86356Q5D 0 Locked

    220 views
    3 replies
    Latest over 1 year ago
    by John Wallace1
<>