Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 You must click Write to Hardware first followed by Store RAM to Flash to store all settings into…
Make sure to use the latest version of the TI Fusion Designer GUI ( Fusion Digital Power Designer ) . TI also provides an "Alert Me" feature to notify the registered users when a new GUI version is available to download.
For more FAQ please check…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The faulted rail is configurable to either shutdown immediate or soft off. This is set at the fault…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 There is a CONTROL signal turnoff configuration: Soft Off (with Sequencing) or Immediately Off.…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 Yes, but it is not recommended to do so. A rail EN pin has many features that logic GPO pins do…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 If the sequence hangs, check at which step the sequence is stuck, then find the cause. For example…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The "time between re-sequences" only starts to count when all rails are below their POWER_GOOD_OFF…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The re-sequencing count is reset when all re-sequencing rails stay above the POWER_GOOD threshold…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The retry count is reset whenever the rail stays above the POWER_GOOD threshold for a TON_MAX_FAULT_LIMIT…
