TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] BQ25628EVM: .bqz file for BQ25628 EVM and BQ25620 EVM

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ25628EVM Other Parts Discussed in Thread: BQSTUDIO , BQ25628 , BQ25620 Please send me the .bqz file for BQ25628 EVM as it's not available in latest bqStudio. Also please send me the .bqz file for the BQ25620 EVM as it's not available…
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS7H5001-SP: How do I use the TPS7H500X-SP family as a voltage mode controller?

    Daniel Hartung
    Daniel Hartung
    Part Number: TPS7H5001-SP The TPS7H500X-SP family of devices are innately set-up for current mode control. Am I able to use the controller as a voltage mode controller?
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ24610: What is the proper placement of bypass capacitors on VREF, VCC, and REGN for BQ24610 and other BQ246xx devices?

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24610 Please place all decoupling capacitors as close as possible to the IC pin they correspond to (following the Layout Guidelines and priorities for each device). However, please make sure that the VREF, VCC, and REGN pins are not loaded…
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS23731: Vout setting on diode rectification and primary-side regulation (affect by VFCP)

    Satoshi
    Satoshi
    Part Number: TPS23731 I considering TPS23731 with diode rectification and primary-side regulation, referenced by answered below E2E thread. https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1169390/tps23731…
    • Answered
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87745-Q1: Where can I find functional safety documents and full data sheet?

    Ishtiaque Panhwar
    Ishtiaque Panhwar
    Part Number: LP87745-Q1 The functional safety documents and full data sheet can be requested through following request link on product folder at https://www.ti.com/product/LP87745-Q1?keyMatch=LP8774-Q1 . Thanks!
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87745-Q1: What is the naming convention of device part number?

    Ishtiaque Panhwar
    Ishtiaque Panhwar
    Part Number: LP87745-Q1 It is explained as following; LP8774 x x xx RXV R Q1 x : Number of regulators x : Switching Frequency (Fsw) and BOM/performance optimized options (1,2,or 3) LP8774x 1 : 17.6 MHz + full performance option or BOM/cost…
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8758-B0: Can TI provide a solution size for the device?

    Phil Yi
    Phil Yi
    Part Number: LP8758-B0 Yes; the EVM design linked below can provide a reference of the solution size for these devices in every phase configurations: https://www.ti.com/tool/LP8758EVM?keyMatch=&tisearch=search-everything&usecase=hardware The picture…
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8758-E0: Does TI have other existing OTP variants for quicker and easier samples?

    Phil Yi
    Phil Yi
    Part Number: LP8758-E0 Yes; listed in table picture below are existing OTP variants available for samples. Any new OTP variant needs to meet certain business size to start the process; please contact your local TI sales for more details.
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] LM26480: Is there a reference design of power up sequence implemented by RC delay on EN pin?

    Phil Yi
    Phil Yi
    Part Number: LM26480 Yes; a set of RC (Resistor and Capacitor) values were used on TI LM26480 EVM with VCC=3.3V on 3 "EN" pins (ENSW2, ENLDO1, ENLDO2) to control the power up delay for the sequence. ENSW1 connects to VCC directly without RC delay. …
    • over 2 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ76952: Mask registers for Alarm Raw Status

    Francis Jiang
    Francis Jiang
    Part Number: BQ76952 Hi Team, I would like to ask a question: what is the mask registers? I am confused about the following words: Thanks a lot. BRs, Francis
    • over 2 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    TINA/Spice/LMG1020EVM-006: LASER CURRENT MEASUREMENT 0 Locked

    1134 views
    5 replies
    Latest over 6 years ago
    by Lixing Fu
  • Suggested Answer

    BQ24195: OTG pin high and VBUS_STAT = 01 (USB Host) does not always give 500mA IINLIM 0 Locked

    320 views
    1 reply
    Latest over 6 years ago
    by Joel Hernandez II
  • Suggested Answer

    TPS544C25: TPS544C25 MTBF/FIT value 0 Locked

    306 views
    1 reply
    Latest over 6 years ago
    by Mathew Jacob1
  • Suggested Answer

    TPS7B7702-Q1: Vout behavior when Vin drop down 0 Locked

    315 views
    1 reply
    Latest over 6 years ago
    by Ryan Eslinger
  • Answered

    BQ24296: Do TI have support 13 series Li battery charger IC? charger current 3A. 0 Locked

    215 views
    1 reply
    Latest over 6 years ago
    by Joel Hernandez II
  • Suggested Answer

    Positive and negative interface 0 Locked

    454 views
    1 reply
    Latest over 6 years ago
    by Jeff F
  • Answered

    BQ25890H: when OTG mode active, can we detect when charger is connected? 0 Locked

    472 views
    2 replies
    Latest over 6 years ago
    by Joel Hernandez II
  • Suggested Answer

    CSD13202Q2: looking for RDSon @ VGS = 1.5V 0 Locked

    332 views
    1 reply
    Latest over 6 years ago
    by John Wallace1
  • Suggested Answer

    TPS54160: Frequency Compensation Component Selection 0 Locked

    428 views
    2 replies
    Latest over 6 years ago
    by Arief Hernadi
  • Suggested Answer

    TLVH431A-Q1: Min Vin to bypass Vin to Vout directly 0 Locked

    1114 views
    2 replies
    Latest over 6 years ago
    by Ethan T
  • Answered

    BQ25570: Output turns off iregularly even tough no VBAT_UV occurs 0 Locked

    850 views
    3 replies
    Latest over 6 years ago
    by Simon Mahler
  • Answered

    Can anyone suggest a TI part for a flyback or charger pump design? 0 Locked

    528 views
    7 replies
    Latest over 6 years ago
    by Jeff Zhang22
  • Not Answered

    TPS544C20: Leakage Current on CNTL Pin 0 Locked

    266 views
    3 replies
    Latest over 6 years ago
    by Mathew Jacob1
  • Not Answered

    [FAQ] PoE PD Controllers: Operation above 57V 0 Locked

    1030 views
    1 reply
    Latest over 6 years ago
    by Thomas Amlee
  • Answered

    TL1431-SP: Planar Die? 0 Locked

    376 views
    1 reply
    Latest over 6 years ago
    by Kirby Kruckmeyer96848
  • Suggested Answer

    TPS65916: SMPSX_SW has no output voltage 0 Locked

    526 views
    6 replies
    Latest over 6 years ago
    by Nastasha
  • Answered

    UCC28063: UCC28063 VINAC 0 Locked

    380 views
    2 replies
    Latest over 6 years ago
    by Benjamin Lough
  • Answered

    TPS7A45: output capacitor value limitation 0 Locked

    341 views
    1 reply
    Latest over 6 years ago
    by Ryan Eslinger
  • Suggested Answer

    TPS65910: Startup waveform overshoot 0 Locked

    764 views
    10 replies
    Latest over 6 years ago
    by Ahmad_Rashed
  • Suggested Answer

    ULN2803A: Calculating maximum Power dissipation 0 Locked

    637 views
    1 reply
    Latest over 6 years ago
    by Alpha H
<>