TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] UCC27311A-Q1: Using a high-side or half-bridge gate driver as a low-side gate driver

    William Moore
    William Moore
    Part Number: UCC27311A-Q1 Tool/software: What are the considerations for using the high-side output of a half-bridge gate driver as a low-side gate driver? When utilizing a half-bridge driver in a typical half-bridge configuration, an internal level…
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] UCC27301A-Q1: Gate drivers for automotive mobile device wireless charging

    Richard Herring
    Richard Herring
    Part Number: UCC27301A-Q1 Other Parts Discussed in Thread: UCC27282-Q1 Tool/software: Wireless charging for mobile devices in automobiles is a common and convenient feature. These chargers are typically powered from the 12V battery system but in some…
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] BQ25750: What do I need to know about the BQ25750 power path switchover?

    Ethan Galloway
    Ethan Galloway
    Part Number: BQ25750 Tool/software: By default, the BQ25750 has an automatic power path switchover. When the VAC power is out the of range set by the ACUV/ACOV resistors, system power will change to VBAT. When VAC is in range again, system power will…
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] What is split output and how to use it?

    Rubas Khalid
    Rubas Khalid
    Other Parts Discussed in Thread: LMG1020 , UCC57108 TI gate drivers use a pull-up and pull-down structure in the output stage in order to drive a power device. The pull-up structure supplies the source current to turn on the power device, and the pull…
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] BQ40Z50: How to do a two-word override MAC sequence ???

    Jose Couso
    Jose Couso
    Tool/software: I am trying to override the Temperature by sending ManufacturerAccess() 0x3008 WriteTemp, but it does not work. What am I doing wrong?
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] What happens when output overshoot or undershoot occurs and how to address it?

    Rubas Khalid
    Rubas Khalid
    TI's gate drivers use a pull-up and pull-down structure in order to drive the output stage. The pull-up structure supplies the source current to turn on the power device, and the pull-down structure supplies the sink current to turn off the power device…
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] BQ2589x FAQs

    Wyatt Keller
    Wyatt Keller
    Other Parts Discussed in Thread: BQ25892 , BQ25895 , BQ25895M , BQ25890H , BQ25890 , BQ25896 , BQ25898 , BQ25898D , BQ25898C BQ2589x FAQ Home Page This home page is for common questions in relation to the BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M…
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890H: Differences between BQ25890 and BQ25890H

    Garrett Kreger
    Garrett Kreger
    Part Number: BQ25890H Other Parts Discussed in Thread: BQ25890 , Tool/software: The differences on the BQ25890H compared to the BQ25890 are as follows. At startup in charge mode the H version not only does regular D+/D- detection the same as BQ25890…
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] BQ76952: BQ76952EVM cell simulator

    Wenjia Qi
    Wenjia Qi
    Part Number: BQ76952 Tool/software: On the BQ76952 EVM, there is a resistive cell simulator made up of 200-Ω series resistors (BQ76952EVM User's Guide (Rev. A) Fig. 5-10). I want to know how to install this cell simulator.
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
  • [FAQ] LP5812: Quick program steps guide for LP5812, LP5810

    Jared Zhou
    Jared Zhou
    Part Number: LP5812 Other Parts Discussed in Thread: LP5810 , Tool/software: How to program LP5812, LP5810 in direct drive mode or TCM drive mode with auto or manual control?
    • Answered
    • over 1 year ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TPS40304: How to get Itrans(Max) current for equation 23 on page 20/39 0 Locked

    371 views
    1 reply
    Latest over 8 years ago
    by Arief Hernadi
  • Answered

    BQ25606: VBUS voltage drop after USB removal 0 Locked

    2424 views
    8 replies
    Latest over 8 years ago
    by Franz Schroeder
  • Not Answered

    LDO 0 Locked

    758 views
    3 replies
    Latest over 8 years ago
    by LeonardEllis
  • Answered

    UCC28810: The TINA module for UCC28810EVM 0 Locked

    739 views
    1 reply
    Latest over 8 years ago
    by Benjamin Lough
  • Answered

    BQ77PL900: BQ77PL900 SDA line becomes low ?? 0 Locked

    3939 views
    12 replies
    Latest over 8 years ago
    by WM5295
  • Answered

    UCC27524A1-Q1: What is the difference between UCC27524A1-Q1 and UCC27524A-Q1? 0 Locked

    1186 views
    2 replies
    Latest over 8 years ago
    by Richard Herring
  • Suggested Answer

    LM5100A: Two-Switch Forward Converter bootstrapped gate driver 0 Locked

    3285 views
    3 replies
    Latest over 8 years ago
    by tynmon
  • Answered

    BQ27426: Chem ID is different between cell spec and GPCCHEM report 0 Locked

    851 views
    2 replies
    Latest over 8 years ago
    by Che yi Su
  • Suggested Answer

    PIC microcontroller based Battery monitoring 0 Locked

    2118 views
    3 replies
    Latest over 8 years ago
    by WM5295
  • Answered

    TPS61222: Product Suggestion 0 Locked

    479 views
    1 reply
    Latest over 8 years ago
    by Jasper Li
  • Suggested Answer

    TPS65381A-Q1: VDD1_OV/UV SM Questions 0 Locked

    570 views
    1 reply
    Latest over 8 years ago
    by Scott Monroe
  • Suggested Answer

    General question: Which is more noisy: Buck or boost? 0 Locked

    480 views
    1 reply
    Latest over 8 years ago
    by Chris Glaser
  • Answered

    Boost converter with low EMI raidation 0 Locked

    1494 views
    5 replies
    Latest over 8 years ago
    by Helen chen
  • Answered

    TPS63070: Output voltage stability 0 Locked

    838 views
    3 replies
    Latest over 8 years ago
    by Sabrina
  • Not Answered

    UCD3138A 0 Locked

    839 views
    2 replies
    Latest over 8 years ago
    by Hung-Jin Chen
  • Answered

    TPS56528: Output discharge 0 Locked

    331 views
    2 replies
    Latest over 8 years ago
    by Anthony Lang
  • Answered

    TPS62410-Q1: TPS62410-Q1 Unused channel 0 Locked

    605 views
    3 replies
    Latest over 8 years ago
    by Juergen
  • Suggested Answer

    TPS40304: How is the value of RCS(R8) chosen 0 Locked

    589 views
    3 replies
    Latest over 8 years ago
    by Angie Neo
  • Suggested Answer

    LM25085A: LM25085A Ripple Configurations Circuit Question. 0 Locked

    1695 views
    8 replies
    Latest over 8 years ago
    by Bob Lee62837
  • Suggested Answer

    Bq76930 0 Locked

    635 views
    1 reply
    Latest over 8 years ago
    by Akilan G
<>