TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM62L ( AM62L32 , AM62L31 ): Custom Board Hardware design - PORz and RTC_PORz slew rate

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts, Usually add RC filter on RESET signal to anti-noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms, can it meet AM62x reset…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: Enable Display Frame Freeze safety feature in openvx

    Gokul S
    Gokul S
    Part Number: TDA4VH-Q1 Tool/software: DSS includes a hardware-enabled freeze frame checker at each pipeline output and vp output. When enabled, it generates a data signature of pixels from a user define region for each frame. The current frame signature…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ) Design Recommendations / Custom board hardware design – Guidelines and E2E query links for custom board designers to refer

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts I see the below status on TI.com for AM62L Can you provide additional inputs on the collaterals to be referred or guidelines to follow during custom board design
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - Supported bootmode configurations

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM62D-Q1 , AM625 , AM623 , AM620-Q1 Tool/software: Hi TI experts help me understand the supported bootmode configurations for the below family of processors AM625 / AM623 / AM620-Q1 / AM64x …
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ) Design Recommendations / Custom board hardware design – Queries regarding power architecture including PMIC

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: TPS65214 , TPS22918 Tool/software: Hi TI Experts, I am designing custom board using AM62L. Can you provide your inputs on the supported power architecture when custom board design is configured…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62P: How to Fix Missing TIFSSTUB to enable Low Power Modes in Linux SDK 10.0/10.1?

    Anshu Madwesh
    Anshu Madwesh
    Part Number: AM62P Tool/software: I've successfully tested low power modes on AM62P using the default images. But I've tried to build my own U-Boot images, but now low power modes are not working. What is the cause and solution to this?
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62L ( AM62L32 , AM62L31 ) Why is MMC1 powered by two different voltage supplies, VDDSHV1 and VDDSHV3 ?

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts, Could you confirm that the voltage domains are correct for the MMC1_SDCD and MMC1_SDWP pins? The datasheet shows both MMC0 and MMC2 as having all member pins bellowing to the same voltage domain.…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to address the gPTP Sync failure post reset recovery of CPSW in Ethenret Firmware?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Tool/software: After a CPSW reset recovery from ETHFW, gPTP fails to re-establish synchronization, impacting time-sensitive applications.
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Building and Booting an UBIFS-based Linux rootfs from OSPI NOR Flash using TI Processor SDK Linux v11.x Yocto Sources

    Andreas Dannenberg
    Andreas Dannenberg
    Part Number: SK-AM64B Other Parts Discussed in Thread: SK-AM62B Tool/software: Overview The TI SK-AM64B EVM has an on-board 64MB-sized OSPI Flash chip that can be used to boot the AM64x device from. The documentation associated with SDK v11.0 contains…
    • 4 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x / AM62Ax / AM62Px / AM62D-Q1 - .alg (ASCII) file for use with Altium tool

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , SK-AM62A-LP , , AM62L , SK-TDA4VM Tool/software: Hi Board Designers, Refer below query related to availability of ASCII…
    • Answered
    • 4 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198401 Discussions
  • Not Answered

    CCS v4 on OMAPL138 Experimenter's Kit --does it stop the ARM side from running? 0 Locked

    169 views
    1 reply
    Latest over 12 years ago
    by Rahul Prabhu
  • Not Answered

    ezDSP Stick Floating Point Operations 0 Locked

    1258 views
    14 replies
    Latest over 12 years ago
    by Archaeologist
  • Not Answered

    DM368 artefact 0 Locked

    344 views
    3 replies
    Latest over 12 years ago
    by pgQuest
  • Not Answered

    tvp5150am1 and variscite module (var-som-am35) 0 Locked

    571 views
    0 replies
    Started over 12 years ago
    by David Montoya
  • Not Answered

    DM814x EZSDK edid checksum calc seems wrong 0 Locked

    312 views
    1 reply
    Latest over 12 years ago
    by Sujith
  • Answered

    Building DDR and Ethernet demo for DSPC 8681 E (TMS320C6678) 0 Locked

    283 views
    3 replies
    Latest over 12 years ago
    by Chad Courtney
  • Answered

    SRIO DirectIO: NWRITE - priority of fragmented packet 0 Locked

    287 views
    1 reply
    Latest over 12 years ago
    by tscheck
  • Not Answered

    Using DDR3 with AM3359 0 Locked

    522 views
    2 replies
    Latest over 12 years ago
    by Rogerio Almeida
  • Not Answered

    tvp5150am1 issue AM3517 0 Locked

    223 views
    0 replies
    Started over 12 years ago
    by David Montoya
  • Not Answered

    Integrating codec server with dsplink loop(dsp side) application in DVSDK. 0 Locked

    2308 views
    23 replies
    Latest over 12 years ago
    by janet
  • Answered

    About SRIO swrite destination Address bit number 0 Locked

    358 views
    1 reply
    Latest over 12 years ago
    by tscheck
  • Answered

    OMAP-L138 EVM (c6748) - trigger external device on j22 pin (GP8[0]) 0 Locked

    361 views
    2 replies
    Latest over 12 years ago
    by Abebe Hailu
  • Not Answered

    watchdog timer interrupt in C6748 0 Locked

    612 views
    3 replies
    Latest over 12 years ago
    by Mukul Bhatnagar
  • Not Answered

    OpenMAX application debugging with gdb/gdbserver 0 Locked

    2898 views
    30 replies
    Latest over 12 years ago
    by Joel Keller
  • Answered

    AM335x CPSW Ethernet queries 0 Locked

    861 views
    3 replies
    Latest over 12 years ago
    by peaves
  • Not Answered

    How to set UART with high baud rate? 0 Locked

    4748 views
    5 replies
    Latest over 12 years ago
    by Miroslav Kiradzhiyski XID
  • Answered

    Neon SIMD coprocessor 0 Locked

    979 views
    2 replies
    Latest over 12 years ago
    by Rogerio Almeida
  • Answered

    About XDMA_EVENT_INTR0 pin (A15 for ZCZ pkg) on AM335x 0 Locked

    1825 views
    6 replies
    Latest over 12 years ago
    by peaves
  • Suggested Answer

    EDMA3 GPIO Synchronization in OMAP-L138 0 Locked

    380 views
    3 replies
    Latest over 12 years ago
    by Mike Looijmans
  • Not Answered

    OMAP/TMS320C674x vs Blackfin 548 0 Locked

    232 views
    0 replies
    Started over 12 years ago
    by Alexey Nuyanzin1
<>