TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to flash GPMC-NAND with Lauterbach JTAG on AM62x

    Hong Guan64
    Hong Guan64
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP Tool/software: AM62x boot rom supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0 compatible…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to generate GPIO interrupt on both falling and rising edge?

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Tool/software: How to configure GPIO interrupt for both rising and falling edge? How to identify which edge (i.e. rising or falling) generates interrupt?
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: PCIe clock architecture

    Bruno B
    Bruno B
    Part Number: AM6442 Tool/software: HI Should we understand that COMMON CLOCK ARCHITECTURE is mandatory (therefore external source also is) whatever the clock being spread spectrum or not ? with best regards Bruno
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] : AM6X Device Reset Troubleshooting Document

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: Many users are asking how to investigate the Reset source when the device continuously getting resting. The below FAQ brief can be helpful to find the Reset reason . The FAQ mainly focuses on AM64X devices, but…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625: Configuring Am625 ALW usb0 in host mode

    naveenkumar Muthusamy
    naveenkumar Muthusamy
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP Tool/software: Hi all, we are trying to configure usb0 to work as host so that when we connect a device like usb it will read the data from the…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL-Q1: Decode H264 and H265 data using V4L2 and Display the same using RTOS driver

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VL-Q1 Tool/software: An application to Decode H264 and H265 data using V4L2 and Display the same using RTOS driver
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x / AM243x Design Recommendations / Custom board hardware design – Dynamic Voltage Scaling for SOC core (VDD_CORE), Peripheral Core and Analog supplies

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: HI TI experts, I have a question on the SOC ROC and Dynamic Voltage scaling. I see the Core Voltage being 0.75V or 0.85V Does the AM6x processor families support dynamic voltage scaling
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62Ax / AM62Px / AM62D-Q1 / AM62L / AM64x Design Recommendations / Custom board hardware design - Starter kit / EVM variants (versions) and Key devices (components) list

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , SK-AM62A-LP , SK-AM62P-LP , AM62D-Q1 Tool/software: Hi TI Experts, Is there a list of TI SK/EVMs for AM6x processor families…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How do we set/configure a specific MAC address for an ETHFW virtual client?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: How do we set/configure a specific MAC address for an ETHFW virtual client?
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1: Custom Board Hardware design - IBIS Model Inquiry

    Evan Wang
    Evan Wang
    Part Number: AM62A1-Q1 Other Parts Discussed in Thread: AM62A3 , AM62A7 Tool/software: Hi Team, Hope you're doing well. Could you share the IBIS model of AM62A12AQMSIAMBRQ1 under different temp?(-40oC/25oC/85oC) Thank you.
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198034 Discussions
  • Not Answered

    ECC error message when SPL loads u-boot 0 Locked

    1112 views
    2 replies
    Latest over 12 years ago
    by Gopher79
  • Answered

    Enabling GPIO interrupt while waiting console input through CCS 0 Locked

    925 views
    3 replies
    Latest over 12 years ago
    by Taejoon Kim
  • Answered

    CCS console input without halting system 0 Locked

    417 views
    2 replies
    Latest over 12 years ago
    by Taejoon Kim
  • Answered

    where to download omapflash v4.15? 0 Locked

    2325 views
    4 replies
    Latest over 12 years ago
    by sunshine bai
  • Not Answered

    Function profiling 0 Locked

    134 views
    0 replies
    Started over 12 years ago
    by John Fisher
  • Answered

    AM3517 GMII I/F 0 Locked

    184 views
    1 reply
    Latest over 12 years ago
    by peaves
  • Not Answered

    unrecoverable error: OMX_ErrorUndefined (0x80001001) 0 Locked

    1090 views
    2 replies
    Latest over 12 years ago
    by Viet Dinh
  • Not Answered

    cannot put C6748 into DEEPSLEEP. 0 Locked

    1401 views
    10 replies
    Latest over 12 years ago
    by Mukul Bhatnagar
  • Answered

    REFCLK on BOC 0 Locked

    205 views
    1 reply
    Latest over 12 years ago
    by Steven Ji
  • Answered

    Error: Failed to create video encoder: h264enc 0 Locked

    2168 views
    4 replies
    Latest over 12 years ago
    by he he1
  • Not Answered

    Route DM6437-DDR2 without terminal resistors 0 Locked

    153 views
    0 replies
    Started over 12 years ago
    by Russell Ak
  • Not Answered

    Power supply of Two C6678 EVMs with Break Out Card Setup 0 Locked

    254 views
    3 replies
    Latest over 12 years ago
    by Delared Delared
  • Answered

    C2000 drivers safe to use with SYS/BIOS? 0 Locked

    751 views
    4 replies
    Latest over 12 years ago
    by Anguel
  • Not Answered

    Trouble with Lukas_Kanade Tracker 0 Locked

    417 views
    2 replies
    Latest over 12 years ago
    by Russell Ak
  • Not Answered

    Simulink VLIB: error S-Function does not exist 0 Locked

    1623 views
    1 reply
    Latest over 12 years ago
    by Russell Ak
  • Not Answered

    How can I get the C55BootImage.exe tool and documents? 0 Locked

    537 views
    2 replies
    Latest over 12 years ago
    by Hyun Kim
  • Answered

    Traffic Class in PCIe 0 Locked

    5686 views
    3 replies
    Latest over 12 years ago
    by Steven Ji
  • Not Answered

    How to set and verify SmartReflex functionality of DM8148? 0 Locked

    606 views
    10 replies
    Latest over 12 years ago
    by Viet Dinh
  • Not Answered

    DM8148 vs DM8168 EMAC 0 Locked

    661 views
    7 replies
    Latest over 12 years ago
    by Vladimir-XID
  • Suggested Answer

    TMS320C5515 - Support 0 Locked

    86 views
    1 reply
    Latest over 12 years ago
    by Steve Tsang
<>