Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM6442
This FAQ showcase how to use the following TISCI APIs in AM64x/AM243x MCU+SDK - TISCI_MSG_READ_KEYCNT_KEYREV - TISCI_MSG_WRITE_KEYREV
Part Number: AM62x, AM62Ax, AM64x, AM65x
Overview
Multilib is one of the solutions allowing users to run applications built for various application binary interfaces (ABIs) of the same architecture. One use of this is to run 32-bit applications built…
Part Number: AM335x, AM437x, AM62x, AM62Ax, AM64x, AM65x
Overview
This E2E FAQ shows an alternative approach of how to use an Yocto-internal toolchain for image builds as well as for the associated SDK installer generation that contains the cross…
Other Parts Discussed in Thread: AM620-Q1 , AM62P , AM625 , SK-AM62P-LP Hi TI Experts,
I have the below queries regarding the OLDI interface
Supported display configurations. Query regarding 8-lane, 4-lane and electrical compatibility.
Is there…
Part Number: TDA4VM I do not have UART boot mode on my custom board due to lack of switch / pins which can configure the boot mode. Is there a way by which I can change the boot mode in software using gel scripts?
Part Number: PROCESSOR-SDK-J721E By default trace and assert functionalities are disabled in the VHWA PDK driver. This article explains how to enable it in the VHWA drivers.
Part Number: SK-AM64B Other Parts Discussed in Thread: TCA9538
Hello TI,
I’m currently working on TI’s SK-AM64B boards, trying to move them from HS-FS to HS-SE mode.
To do so, I’m using the OTP Keywriter tool with MCU+ SDK for AM64x in its latest…
