TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198193 Discussions
  • Answered

    GRE Protocol packets reception in NDK. 0 Locked

    444 views
    5 replies
    Latest over 12 years ago
    by Eric Ruei
  • Not Answered

    The most efficient IPC mechanism on C6678 0 Locked

    2425 views
    10 replies
    Latest over 12 years ago
    by Viktor Maier
  • Discussion

    VOLIB, TDU, tduGetSizes can't return right value Locked

    471 views
    5 replies
    Latest over 12 years ago
    by lding
  • Answered

    still video decoding 0 Locked

    86 views
    2 replies
    Latest over 12 years ago
    by ranchu
  • Discussion

    [PATCH] DM81XX: use one clock cycle granularity to set SPI clock speed Locked

    368 views
    0 replies
    Started over 12 years ago
    by Delio Brignoli
  • Not Answered

    AM335x NAND not found 0 Locked

    352 views
    0 replies
    Started over 12 years ago
    by Eliah Ninyo
  • Not Answered

    the power suspend issue with ICS in beaglebone 0 Locked

    192 views
    0 replies
    Started over 12 years ago
    by zzw
  • Not Answered

    Maximum size of SDXC card support on ezsdk/dvr_rdk for DM81xx 0 Locked

    213 views
    1 reply
    Latest over 12 years ago
    by Pavel Botev
  • Not Answered

    Problem in decoding MPEG4 stream. 0 Locked

    200 views
    1 reply
    Latest over 12 years ago
    by Pavel Botev
  • Not Answered

    PLL Comes Up in PLL Mode Instead of Bypass on C6678 0 Locked

    808 views
    8 replies
    Latest over 12 years ago
    by xi su
  • Not Answered

    powerlink example xdd file validation Error 0 Locked

    446 views
    0 replies
    Started over 12 years ago
    by Moonsun Park
  • Not Answered

    Low level DSS&HDMI programming 0 Locked

    178 views
    0 replies
    Started over 12 years ago
    by Christian_B
  • Answered

    ICE & EtherCAT slave source 0 Locked

    2590 views
    14 replies
    Latest over 12 years ago
    by PratheeshGangadhar
  • Not Answered

    AM335X Starter Kit Serial Port Not working 0 Locked

    1115 views
    4 replies
    Latest over 12 years ago
    by Sujith KV
  • Not Answered

    regarding booting dvm816x board using tftp. 0 Locked

    137 views
    1 reply
    Latest over 12 years ago
    by Michael T
  • Answered

    FAXLIB source code? 0 Locked

    358 views
    1 reply
    Latest over 12 years ago
    by lding
  • Not Answered

    omap4430 win EC7 0 Locked

    143 views
    0 replies
    Started over 12 years ago
    by chandrakanth pokuru1
  • Answered

    Burning uboot.min.nand to Nand Flash ,show message Verify failed. Attempting to clear page 0 Locked

    779 views
    7 replies
    Latest over 12 years ago
    by gong li
  • Not Answered

    How To Port Display Driver for Different LCD ? WEC7-AM335x EVM 0 Locked

    305 views
    2 replies
    Latest over 12 years ago
    by Anant Wakode
  • Answered

    Using AM3359 internal memory 0 Locked

    495 views
    6 replies
    Latest over 12 years ago
    by John Conover
<>