Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: PROCESSOR-SDK-J721E
This is more of an fyi if you want to connect an NVME SSD drive to the J721 EVM.
The drive i bought is
https://www.amazon.com/gp/product/B08V83JZH4/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1
once you get…
Part Number: DRA821U Other Parts Discussed in Thread: DRA821 How to test RGMII configuration with DRA821 on EVM ? As only SGMII is enabled by default ?
Part Number: TDA4VM Other Parts Discussed in Thread: SYSBIOS Where can I find the resource table for IPC application running on MCU1_0. Also, what resource table should I use when loading another core?
Part Number: TDA4VM
To enable fast CAN response, I need to use SBL to load MCU1_0 image (either AUTOSAR or TI-RTOS).
boot_app_mcu_rtos is the demo ap p in SDK release for the early CAN response implementation. The boot app inside can be used to boot…
Part Number: J7200XSOMXEVM Other Parts Discussed in Thread: DRA821 I have got the DRA821 EVM (J7200 SOM, and J7 common processor board), and also the "Quad-Port Ethernet expansion board" (a.k.a QSGMII expansion board).
J7200 SOM: https://www.ti.com…
Part Number: DRA821U Other Parts Discussed in Thread: DRA821
I am working on a customer DRA821 board.
As the default UART port isn't available for the ethernet firmware log output. How can I change the log output to another UART instance?
Part Number: TDA4VM I do not see the eth1 interface when booting up with Linux on J7200/J721E devices using SD Card, there is no output on 3rd Main UART instance as well where Ethernet Firmware output usually comes.
