TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198150 Discussions
  • Not Answered

    Serial UART port using GPIO pins 0 Locked

    3574 views
    2 replies
    Latest over 13 years ago
    by Avi Chami1
  • Not Answered

    DM365 IPIPE 420 Semiplaner to 422 UYVY conversion 0 Locked

    2517 views
    17 replies
    Latest over 13 years ago
    by vipul mahajan
  • Answered

    Beaglebone DDR2 bandwidth. 0 Locked

    429 views
    1 reply
    Latest over 13 years ago
    by Iulian Gheorghiu
  • Answered

    alsa of omapl138 dvsdk_04_03_00_06 0 Locked

    270 views
    2 replies
    Latest over 13 years ago
    by huang jack
  • Not Answered

    1.8 V to 3.3 V level shifter 0 Locked

    385 views
    1 reply
    Latest over 13 years ago
    by BrandonAzbell
  • Answered

    _SEM_post and _SEM_postBinary map location 0 Locked

    1967 views
    6 replies
    Latest over 13 years ago
    by Oliver Francis
  • Answered

    Preparing a working project to program into EEPROM 0 Locked

    1351 views
    13 replies
    Latest over 13 years ago
    by dilip kumar
  • Not Answered

    Sitara AM3352 Mystical DDR2 problem 0 Locked

    271 views
    1 reply
    Latest over 13 years ago
    by BrandonAzbell
  • Not Answered

    How do I modify tvdevicedesc.xml 0 Locked

    326 views
    0 replies
    Started over 13 years ago
    by bruce lin
  • Answered

    AM317evm NAND flash memory, UIBFS ECC errors at boot time 0 Locked

    1576 views
    9 replies
    Latest over 13 years ago
    by Renjith Thomas
  • Not Answered

    About DM368 ISIF C_WEN signal 0 Locked

    247 views
    0 replies
    Started over 13 years ago
    by yang camel
  • Not Answered

    minimum time for release of reset after powerup on OMAPL-138 0 Locked

    221 views
    2 replies
    Latest over 13 years ago
    by jack steel
  • Answered

    Multi-channel or Multi-instance for best VIP port performance? 0 Locked

    322 views
    2 replies
    Latest over 13 years ago
    by Brijesh Jadav
  • Not Answered

    L2 is not enough 0 Locked

    407 views
    4 replies
    Latest over 13 years ago
    by Douglas Gwyn
  • Not Answered

    6713's L2 has cache, how much performance will improve 0 Locked

    254 views
    2 replies
    Latest over 13 years ago
    by Douglas Gwyn
  • Not Answered

    6670 eval board demod capacity 0 Locked

    149 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    How can I enable Analog Video output with DVI? 0 Locked

    230 views
    1 reply
    Latest over 13 years ago
    by Brahim HAMADICHAREF
  • Not Answered

    OMAP3530 Interfacing 0 Locked

    241 views
    4 replies
    Latest over 13 years ago
    by Brahim HAMADICHAREF
  • Not Answered

    which pad mode on saving power consumption 0 Locked

    89 views
    0 replies
    Started over 13 years ago
    by yuanjun ren
  • Answered

    JTAG for AM335x EVM 0 Locked

    1206 views
    3 replies
    Latest over 13 years ago
    by vipul mahajan
<>