TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197743 Discussions
  • Answered

    gst-openmax decoder output exactly same yuv buffers 0 Locked

    566 views
    1 reply
    Latest over 13 years ago
    by Satheeshvarma Janakiraman
  • Answered

    C6678 Jtag problem 0 Locked

    1961 views
    14 replies
    Latest over 13 years ago
    by Bonzai
  • Not Answered

    UART1, 2, 3 are not working on Linux? 0 Locked

    2260 views
    15 replies
    Latest over 13 years ago
    by LU ZHOU
  • Not Answered

    SPI communication 0 Locked

    121 views
    0 replies
    Started over 13 years ago
    by Aquiles Lacruz
  • Not Answered

    Some inquiries about the Ethernet boot process of EVM6678 0 Locked

    1700 views
    33 replies
    Latest over 13 years ago
    by Greg Reuter
  • Answered

    OM4460 TRM 0 Locked

    496 views
    3 replies
    Latest over 13 years ago
    by Egor Rumjantsev
  • Not Answered

    SPI user space access 0 Locked

    1998 views
    13 replies
    Latest over 13 years ago
    by wish_best
  • Not Answered

    Running program on a TMS320C6713 DSK without having to plug it in the computer 0 Locked

    309 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    dm6467 how to decode a digital broadcast (over the air free digital tv). 0 Locked

    188 views
    1 reply
    Latest over 13 years ago
    by philip lee46717
  • Not Answered

    How to use DM3730's UART4 as a serial console? 0 Locked

    450 views
    1 reply
    Latest over 13 years ago
    by Norman Wong
  • Answered

    How to debug SYSBIOS + IPC DSP program with CCSV5.1? 0 Locked

    821 views
    4 replies
    Latest over 13 years ago
    by Ramsey
  • Answered

    Questions about C6678 SmartReflex Power Using LM10010 0 Locked

    631 views
    5 replies
    Latest over 13 years ago
    by Jin HAO
  • Answered

    IPC benchmarking Project Experiments and benchmarks difference 0 Locked

    1069 views
    10 replies
    Latest over 13 years ago
    by RCReddy
  • Not Answered

    Cross Compiling problems with lighttpd 0 Locked

    492 views
    0 replies
    Started over 13 years ago
    by Tyler Buck
  • Not Answered

    Selecting Audio formats 0 Locked

    156 views
    0 replies
    Started over 13 years ago
    by Harman Kalra1
  • Answered

    AM335x EVM does not boot from NAND 0 Locked

    503 views
    3 replies
    Latest over 13 years ago
    by Jin Yu1
  • Not Answered

    MCASP & EDMA 0 Locked

    407 views
    3 replies
    Latest over 13 years ago
    by Ahmed ibrahim
  • Answered

    [OMAP4430 custom board] Ducati & OMX questions (and troubles) 0 Locked

    2063 views
    4 replies
    Latest over 13 years ago
    by Dominik Marszk
  • Not Answered

    DM6467T stalls when encoder starts 0 Locked

    250 views
    1 reply
    Latest over 13 years ago
    by Amir Kamzel
  • Not Answered

    MityDSP (AM1808), StarterWare, and usb_dev_bulk not working. 0 Locked

    275 views
    1 reply
    Latest over 13 years ago
    by Michael S
<>