Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300
Tool/software:
Hi TI Experts,
Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
Part Number: AM6422 Other Parts Discussed in Thread: AM6442
Tool/software:
Hi,
I am using the AM6442 Processor Evaluation Kit. We’ve been testing the Clock Loss Detection feature of the AM64x.
We provided a 25 MHz external clock to the processor…
Part Number: AM62L Other Parts Discussed in Thread: SYSCONFIG , AM62A3 , AM62P , AM62D-Q1
Tool/software:
Hi TI Experts,
Could you please elaborate about PADCONFIG register bits and default configurations for PADCONFIG registers.
Part Number: AM62L Other Parts Discussed in Thread: AM62P , SYSCONFIG , AM62P5-Q1 ,
Tool/software:
Hi TI Experts,
Is there a list of design recommendations or commonly observed errors for SD card Interface during Custom board hardware design?
Below…
Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG Tool/software: I was using the __attribute__((constructor(x) / destructor(y)) property in C code for A53 core with GCC compiler.
the GCC attribute is __attribute__((destructor…
Part Number: AM62A7 Other Parts Discussed in Thread: SK-AM62A-LP
Tool/software:
TIFS trace log is a useful debug tool to analyze TIFS firmware operations [1] [2]. There's an issue on capturing TIFS trace log from MAIN_UART1 port with AM62A Linux SDK…
Part Number: AM67 Tool/software: I would like to do a PCIe compliance test to see if my AM6x PCIe device meets the standards set by PCI-SIG. What is the procedure to run this test?
Part Number: DRA821U-Q1 Tool/software: How can I enable the RGMII2 interface from the CPSW5G Ethernet switch on the DRA821-Q1 TI EVM using the native Linux driver?
